Key parameters and optimal design of a single-layered induction coil for external rapid mold surface heating
- 1 October 2014
- journal article
- Published by Elsevier BV in International Communications in Heat and Mass Transfer
- Vol. 57, 109-117
- https://doi.org/10.1016/j.icheatmasstransfer.2014.07.019
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Experimental rapid surface heating by induction for injection molding of large LCD TV framesJournal of Polymer Engineering, 2014
- Rapid mold temperature control in injection molding by using steam heatingInternational Communications in Heat and Mass Transfer, 2010
- Effect of rapid mold surface inducting heating on the replication ability of microinjection molding light-guided plates with V-grooved microfeaturesJournal of Applied Polymer Science, 2010
- Effect of multi-layered induction coils on efficiency and uniformity of surface heatingInternational Journal of Heat and Mass Transfer, 2010
- Mold temperature variation for assisting micro-molding of DVD micro-featured substrate and dummy using pulsed coolingSensors and Actuators A: Physical, 2009
- Experimental rapid surface heating by induction for micro‐injection molding of light‐guided platesJournal of Applied Polymer Science, 2009
- Variable mold temperature to improve surface quality of microcellular injection molded parts using induction heating technologyAdvances in Polymer Technology, 2008
- Simulation of infrared rapid surface heating for injection moldingInternational Journal of Heat and Mass Transfer, 2006
- SIMULATIONS AND VERIFICATIONS OF INDUCTION HEATING ON A MOLD PLATEInternational Communications in Heat and Mass Transfer, 2004
- Development of rapid heating and cooling systems for injection molding applicationsPolymer Engineering & Science, 2002