The Fluid Dynamics of LPT Blade Separation Control Using Pulsed Jets
- 1 February 2001
- journal article
- Published by ASME International in Journal of Turbomachinery
- Vol. 124 (1), 77-85
- https://doi.org/10.1115/1.1425392
Abstract
The effects of pulsed vortex generator jets on a naturally separating low-pressure turbine boundary layer have been investigated experimentally. Blade Reynolds numbers in the linear turbine cascade match those for high-altitude aircraft engines and industrial turbine engines with elevated turbine inlet temperatures. The vortex generator jets (30 deg pitch and 90 deg skew angle) are pulsed over a wide range of frequency at constant amplitude and selected duty cycles. The resulting wake loss coefficient versus pulsing frequency data add to previously presented work by the authors documenting the loss dependency on amplitude and duty cycle. As in the previous studies, vortex generator jets are shown to be highly effective in controlling laminar boundary layer separation. This is found to be true at dimensionless forcing frequencies F+ well below unity and with low (10 percent) duty cycles. This unexpected low-frequency effectiveness is due to the relatively long relaxation time of the boundary layer as it resumes its separated state. Extensive phase-locked velocity measurements taken in the blade wake at an F+ of 0.01 with 50 percent duty cycle (a condition at which the flow is essentially quasi-steady) document the ejection of bound vorticity associated with a low-momentum fluid packet at the beginning of each jet pulse. Once this initial fluid event has swept down the suction surface of the blade, a reduced wake signature indicates the presence of an attached boundary layer until just after the jet termination. The boundary layer subsequently relaxes back to its naturally separated state. This relaxation occurs on a timescale which is five to six times longer than the original attachment due to the starting vortex. Phase-locked boundary layer measurements taken at various stations along the blade chord illustrate this slow relaxation phenomenon. This behavior suggests that some economy of jet flow may be possible by optimizing the pulse duty cycle and frequency for a particular application. At higher pulsing frequencies, for which the flow is fully dynamic, the boundary layer is dominated by periodic shedding and separation bubble migration, never recovering its fully separated (uncontrolled) state.Keywords
This publication has 18 references indexed in Scilit:
- Influence of Turbulence Intensity on Annular Turbine Stator Aerodynamics at Low Reynolds NumbersPublished by ASME International ,1999
- The dynamics of flow reattachment over a thick airfoil controlled by synthetic jet actuatorsPublished by American Institute of Aeronautics and Astronautics (AIAA) ,1999
- Post-stall flow control on an airfoil by local unsteady forcingJournal of Fluid Mechanics, 1998
- Suppression of dynamic stall by steady and pulsed upper-surface blowingPublished by American Institute of Aeronautics and Astronautics (AIAA) ,1998
- Characteristics of an Annular Turbine Cascade at Low Reynolds NumbersPublished by ASME International ,1998
- Numerical model of boundary-layer control using air-jet generated vorticesAIAA Journal, 1994
- Oscillatory Blowing: A Tool to Delay Boundary-Layer SeparationAIAA Journal, 1993
- Forcing level effects of internal acoustic excitation on the improvement of airfoil performanceJournal of Aircraft, 1992
- Streamwise vortex production by pitched and skewed jets in a turbulent boundary layerAIAA Journal, 1992
- Investigation of several passive and active methods for turbulent flow separation controlPublished by American Institute of Aeronautics and Astronautics (AIAA) ,1990