Influence of autoclaving process parameters on the buckling and postbuckling behaviour of thin-walled channel section beams
- 1 December 2014
- journal article
- Published by Elsevier BV in Thin-Walled Structures
- Vol. 85, 262-270
- https://doi.org/10.1016/j.tws.2014.09.007
Abstract
No abstract availableFunding Information
- National Science Center (DEC-2011/03/B/ST8/06447)
This publication has 23 references indexed in Scilit:
- The engineering aspects of automated prepreg layup: History, present and futureComposites Part B: Engineering, 2011
- Coupled quasi-homogeneous orthotropic laminatesMechanics of Composite Materials, 2011
- Characterization of Nonsymmetric Forms of Fully Orthotropic LaminatesJournal of Aircraft, 2009
- Buckling Analysis and Minimum-Mass Design Procedures for Composite Wing-Box StructuresJournal of Aircraft, 2006
- Kinetic analysis of a fast reacting thermoset systemThermochimica Acta, 2005
- Fibre reinforced composites in aircraft constructionProgress in Aerospace Sciences, 2005
- Selection of composite materials and manufacturing routes for cost-effective performanceComposites Part A: Applied Science and Manufacturing, 2002
- Composite materials for aerospace applicationsBulletin of Materials Science, 1999
- Structural design of a composite wind turbine blade using finite element analysisComputers & Structures, 1997
- Effects of cure cycle pressure and voids on some mechanical properties of carbon/epoxy laminatesComposites, 1995