Novel IGV Designs for Centrifugal Compressors and Their Interaction With the Impeller
- 22 June 2011
- journal article
- Published by ASME International in Journal of Turbomachinery
- Vol. 134 (2), 021006
- https://doi.org/10.1115/1.4003235
Abstract
In centrifugal compressors, variable inlet guide vanes (IGVs) are used to control the mass flow rate with negligible change in pressure ratio and shaft speed. The efficient operation of IGVs is limited to the range of aerodynamic stability of their vane profiles. Thin symmetric profiles, which are usually used, tend to exhibit flow separation already at low setting angles, resulting in a rapid decrease in the global efficiency. Three different guide vane profiles, including a symmetric reference profile, a two-piece tandem profile with a variable angle, and an s-cambered profile, together with two auxiliary profiles, were considered. These variants were numerically and experimentally investigated at different setting angles, covering negative and positive inlet swirls, and at different operating points. The results show that tandem and s-cambered vanes have superior aerodynamic performance in comparison with the symmetric reference profile and extend the operating range of the compressor over which the efficiency remains high. The tandem profile shows better aerodynamic performance than the s-cambered profile at negative inlet swirl, while the asymmetric s-cambered profile offers an extended range of high efficiency at positive preswirl. Considering manufacturing requirements and cost, the s-cambered profile is preferred for applications with positive preswirl.Keywords
This publication has 10 references indexed in Scilit:
- Improved Diffuser/Volute Combinations for Centrifugal CompressorsJournal of Turbomachinery, 2008
- Compressible Flow in Inlet Guide Vanes With Mechanical FlapsPublished by ASME International ,2004
- Effect of Suction Elbow and Inlet Guide Vanes on Flow Field in a Centrifugal Compressor StagePublished by ASME International ,2002
- Overshoot of the Rankine Vortex Formed in the Flow Field Behind the Inlet Guide Vane of Centrifugal CompressorsPublished by ASME International ,1999
- Experimental and Numerical Investigation of the Flow in a Centrifugal Compressor VoluteJournal of Turbomachinery, 1999
- The Performance of a Centrifugal Compressor With High Inlet PrewhirlJournal of Turbomachinery, 1998
- Flow Measurements Behind the Inlet Guide Vane of a Centrifugal CompressorPublished by ASME International ,1998
- Entwicklung neuer Schaufelgitter aus Profilen variabler Geometrie zum Einsatz in Leiträdern drallgeregelter Turbomaschinen—Teil IForschung im Ingenieurwesen, 1994
- Improvements in Performance Characteristics of Single-Stage and Multistage Centrifugal Compressors by Simultaneous Adjustments of Inlet Guide Vanes and Diffuser VanesJournal of Turbomachinery, 1987
- Design and Performance of a Fixed, Nonaccelerating Guide Vane Cascade That Operates Over an Inlet Flow Angle Range of 60 DegJournal of Engineering for Gas Turbines and Power, 1985