Suppression of Frost Nucleation Achieved Using the Nanoengineered Integral Humidity Sink Effect
- 29 December 2016
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 11 (1), 906-917
- https://doi.org/10.1021/acsnano.6b07505
Abstract
Inhibition of frost formation is important for increasing efficiency of refrigeration systems and heat exchangers, as well as for preventing the rapid icing over of water-repellant coatings that are designed to prevent accumulation of rime and glaze. From a thermodynamic point of view, this task can be achieved by either increasing hydrophobicity of the surface or decreasing the concentration of water vapor above it. The first approach has been studied in depth, but so far has not yielded a robust solution to the problem of frost formation. In this work, we systematically explore how frost growth can be inhibited by controlling water vapor concentration using bilayer coatings with a porous exterior covering a hygroscopic liquid-infused layer. We lay the theoretical foundation and provide experimental validation of the mass transport mechanism that governs the integral humidity sink effect based on this coating platform as well as reveal intriguing sizing effects about this system. We show that the concentration profile above periodically spaced pores is governed by the sink and source concentrations and two geometrical parameters: the nondimensional pore size and the ratio of the pore spacing to the boundary layer thickness. We demonstrate that when the ratio of the pore spacing to the boundary layer thickness vanishes, as for the nanoporous bilayer coatings, the entire surface concentration becomes uniform and equal to the concentration set by the hygroscopic liquid. In other words, the surface concentration becomes completely independent of the nanopore size. We identified the threshold geometrical parameters for this condition and show that it can lead to a 65 K decrease in the nucleation onset surface temperature below the dew point. With this fundamental insight, we use bilayer coatings to nanoengineer the integral humidity sink effect to provide extreme antifrosting performance with up to a 2 h delay in nucleation onset at 263 K. The nanoporous bilayer coatings can be designed to combine optimal antifrosting functionality with a superhydrophobic water repelling exterior to provide coatings that can robustly prevent frost, rime, and glaze accumulation. By minimizing the required amount of antifreeze, this anti-icing method can have minimal operational cost and environmental impact.Keywords
Funding Information
- Arizona State University
This publication has 62 references indexed in Scilit:
- Activating the Microscale Edge Effect in a Hierarchical Surface for Frosting Suppression and Defrosting PromotionScientific Reports, 2013
- Multimode Multidrop Serial Coalescence Effects during Condensation on Hierarchical Superhydrophobic SurfacesLangmuir, 2013
- Liquid-Infused Nanostructured Surfaces with Extreme Anti-Ice and Anti-Frost PerformanceACS Nano, 2012
- Methodology for Imaging Nano-to-Microscale Water Condensation Dynamics on Complex NanostructuresACS Nano, 2011
- Anti-icing and de-icing techniques for wind turbines: Critical reviewCold Regions Science and Technology, 2010
- Frost formation on a bionic super-hydrophobic surface under natural convection conditionsHeat Transfer, 2008
- Frost formation on a plate with different surface hydrophilicityInternational Journal of Heat and Mass Transfer, 2004
- Subpattern formation during condensation processes on structured substratesEurophysics Letters, 2003
- A fundamental understanding of factors affecting frost nucleationInternational Journal of Heat and Mass Transfer, 2003
- Inhibition of water condensation by a soluble salt nucleusThe Journal of Chemical Physics, 1981