Influences of process parameters on preparation of microparticle used as a carrier system for O - 3 unsaturated fatty acid ethyl esters used in supplementary nutrition

Abstract

Microparticles were prepared by complex coacervation to encapsulate eicosapentaenoic acid ethyl ester (EPA-EE) for incorporation into foods as a nutrition supplement. Gelatin and acacia were used in the coacervation process. With an increasing oil/polymer ratio, both yield and encapsulation rate decreased; with an increasing homogenization time, the yield remained constant while the encapsulation rate slightly increased. Several particle hardening techniques were examined and their influence on particle structure, yield and encapsulation rate were examined. Ethanol hardening was compared to cross-linking with dehydroascrobic acid with respect to both yield and encapsulation rate. The particle diameters for both formulations were similar (ethanol: 38.4 +/- 4.1 microm; cross-linking: 41.8 +/- 3.0 microm). Spray-drying of the coacervates led to the smallest particles (5.2 +/- 1.1 microm), lowest yield and encapsulation rate. All microencapsulation products were assayed for their storage stability over 4 weeks with respect to the oxidation of the encapsulated omega - 3 unsaturated fatty acid ester inside the particles. Hardening with ethanol showed the lowest amount of peroxides: particle wall cross-linking by dehydroascorbic acid and spray-drying were observed to be less protective. All microparticles were characterized for their internal structure with confocal laser scanning microscopy (CLSM) after fluorescence labelling of the polymers, in order to localize the oil phase and visualize the distribution of the polymers in the coacervates. With increasing homogenization time, the internal structure changed stepwise from a capsule structure (core/wall) towards a matrix structure. For all experiments, a homogeneous distribution for both polymers, gelatin and acacia was observed inside the particle wall. No influence of the different particle hardening procedures on the polymer distribution was found.