Study on the residual wall thickness at dimensional transitions and curved sections in gas-assisted molded circular tubes
- 1 January 2002
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 42 (1), 111-119
- https://doi.org/10.1002/pen.10932
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Mechanical properties of gas-assisted injection moulded PS, PP and Nylon partsPolymer, 1999
- Study of ?gas fingering? behavior in gas-assisted injection moldingPolymer Engineering & Science, 1999
- Investigation of gas‐assisted injection molding. Part III: Effect of gas channel design on part bending strengthPolymer Engineering & Science, 1998
- Structural analysis for gas-assisted injection-molded partsAdvances in Polymer Technology, 1997
- A study of rib geometry for gas‐assisted injection moldingPolymer Engineering & Science, 1996
- Isothermal gas‐assisted displacement of viscoplastic liquids in tubesPolymer Engineering & Science, 1995
- Unstable Gas Penetrations in Symmetrical Rib Channels During Gas-assisted Injection MoldingInternational Polymer Processing, 1995
- Simulation and verification of the secondary gas penetration in a gas-assisted-injection molded spiral tubeInternational Communications in Heat and Mass Transfer, 1995
- Development and application of CAE technology for the gas-assisted injection molding processAdvances in Polymer Technology, 1995
- The Gas-assisted Injection Molding ProcessInternational Polymer Processing, 1993