Nanofluid Properties and Their Effects on Convective Heat Transfer in an Electronics Cooling Application
- 1 September 2009
- journal article
- Published by ASME International in Journal of Thermal Science and Engineering Applications
- Vol. 1 (3), 031006
- https://doi.org/10.1115/1.4001123
Abstract
In the search for new, more effective coolant fluids, nanoparticle suspensions have shown promise due to their enhanced thermal conductivity. However, there is a concomitant increase in the viscosity, requiring an increase in pumping power to achieve the same flow rate. Studies of flow cooling in simple geometries indicate that there is a benefit to using nanofluids, but it is difficult to justify extending these results to the far more complicated geometries. Moreover, with the variability of property measurements found in literature, it is possible to show conflicting results from the same set of flow-cooling data. In this work we present a self-contained study of the properties and effectiveness of an alumina in water nanofluid. Flow-cooling is studied in an off-the-shelf fluid cooling package for electronics to examine the effects of the particulates in a practical scenario. We measure the thermal conductivity and viscosity of the same suspensions to assure consistent interpretation of our results. We find that, while there is no anomalous enhancement of the thermal properties or transport, there is a benefit to using a low volume fraction alumina nanoparticle suspension over using the base fluid alone. In fact, there is an optimal volume fraction (1%) for this nanofluid and electronics cooling system combination that maximizes the heat dissipated. However, we find that this benefit decreases as the volume fraction, and hence the viscosity, increases. Understanding where the trade-off between viscosity increase and thermal conductivity increase occurs is critical to designing an electronics cooling system using a nanofluid as a coolant.Keywords
This publication has 39 references indexed in Scilit:
- Laminar convective heat transfer and viscous pressure loss of alumina–water and zirconia–water nanofluidsInternational Journal of Heat and Mass Transfer, 2009
- Charging Behavior at the Alumina–Water Interface and Implications for Ceramic ProcessingJournal of the American Ceramic Society, 2007
- Assessment of the effectiveness of nanofluids for single-phase and two-phase heat transfer in micro-channelsInternational Journal of Heat and Mass Transfer, 2007
- Mechanism of Thermal Transport in Dilute NanocolloidsPhysical Review Letters, 2007
- Effect of uncertainties in physical properties on forced convection heat transfer with nanofluidsApplied Thermal Engineering, 2006
- Turkevich Method for Gold Nanoparticle Synthesis RevisitedThe Journal of Physical Chemistry B, 2006
- Heat transfer of aqueous suspensions of carbon nanotubes (CNT nanofluids)International Journal of Heat and Mass Transfer, 2006
- Heat transfer properties of nanoparticle-in-fluid dispersions (nanofluids) in laminar flowInternational Journal of Heat and Mass Transfer, 2005
- Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditionsInternational Journal of Heat and Mass Transfer, 2004
- HYDRODYNAMIC AND HEAT TRANSFER STUDY OF DISPERSED FLUIDS WITH SUBMICRON METALLIC OXIDE PARTICLESExperimental Heat Transfer, 1998