Machine tool spindle units
Top Cited Papers
- 6 July 2010
- journal article
- Published by Elsevier BV in CIRP Annals
- Vol. 59 (2), 781-802
- https://doi.org/10.1016/j.cirp.2010.05.002
Abstract
No abstract availableKeywords
This publication has 88 references indexed in Scilit:
- Stability-based spindle speed control during flexible workpiece high-speed millingInternational Journal of Machine Tools and Manufacture, 2008
- Selection of design and operational parameters in spindle–holder–tool assemblies for maximum chatter stability by using a new analytical modelInternational Journal of Machine Tools and Manufacture, 2007
- Modeling of spindle-bearing and machine tool systems for virtual simulation of milling operationsInternational Journal of Machine Tools and Manufacture, 2007
- Modeling and identification of tool holder–spindle interface dynamicsInternational Journal of Machine Tools and Manufacture, 2007
- Milling machine spindle analysis using FEM and non-contact spindle excitation and response measurementInternational Journal of Machine Tools and Manufacture, 2007
- Analysis of bearing configuration effects on high speed spindles using an integrated dynamic thermo-mechanical spindle modelInternational Journal of Machine Tools and Manufacture, 2004
- Calculation of the stiffness matrix of angular contact ball bearings by using the analytical approachJournal of Mechanical Design, 2000
- Active Thermal Preload Regulation for Machine Tool Spindles With Rolling Element BearingsJournal of Manufacturing Science and Engineering, 1996
- A State-Space Model for Monitoring Thermally Induced Preload in Anti-Friction Spindle Bearings of High-Speed Machine ToolsJournal of Dynamic Systems, Measurement, and Control, 1994
- Use of Audio Signals for Chatter Detection and ControlJournal of Engineering for Industry, 1992