Occupational Exposure and Environmental Release: The Case Study of Pouring TiO2 and Filler Materials for Paint Production
Open Access
- 7 January 2021
- journal article
- research article
- Published by MDPI AG in International Journal of Environmental Research and Public Health
- Vol. 18 (2), 418
- https://doi.org/10.3390/ijerph18020418
Abstract
Pulmonary exposure to micro- and nanoscaled particles has been widely linked to adverse health effects and high concentrations of respirable particles are expected to occur within and around many industrial settings. In this study, a field-measurement campaign was performed at an industrial manufacturer, during the production of paints. Spatial and personal measurements were conducted and results were used to estimate the mass flows in the facility and the airborne particle release to the outdoor environment. Airborne particle number concentration (1 × 103–1.0 × 104 cm−3), respirable mass (0.06–0.6 mg m−3), and PM10 (0.3–6.5 mg m−3) were measured during pouring activities. In overall; emissions from pouring activities were found to be dominated by coarser particles >300 nm. Even though the raw materials were not identified as nanomaterials by the manufacturers, handling of TiO2 and clays resulted in release of nanometric particles to both workplace air and outdoor environment, which was confirmed by TEM analysis of indoor and stack emission samples. During the measurement period, none of the existing exposure limits in force were exceeded. Particle release to the outdoor environment varied from 6 to 20 g ton−1 at concentrations between 0.6 and 9.7 mg m−3 of total suspended dust depending on the powder. The estimated release of TiO2 to outdoors was 0.9 kg per year. Particle release to the environment is not expected to cause any major impact due to atmospheric dilutionThis publication has 62 references indexed in Scilit:
- Advanced Reach Tool (ART): Development of the Mechanistic ModelThe Annals of Occupational Hygiene, 2011
- New considerations for PM, Black Carbon and particle number concentration for air quality monitoring across different European citiesAtmospheric Chemistry and Physics, 2011
- Nanoparticle exposure at nanotechnology workplaces: A reviewParticle and Fibre Toxicology, 2011
- Design, Calibration, and Field Performance of a Miniature Diffusion Size ClassifierAerosol Science and Technology, 2011
- Comparative Evaluation of the Dustiness of Industrial Minerals According to European Standard EN 15051, 2006The Annals of Occupational Hygiene, 2009
- Conceptual Model for Assessment of Inhalation Exposure: Defining Modifying FactorsAnnals of Work Exposures and Health, 2008
- Stoffenmanager Exposure Model: Development of a Quantitative AlgorithmAnnals of Work Exposures and Health, 2008
- Measurement of Ultrafine Particles: A Comparison of Two Handheld Condensation Particle CountersAerosol Science and Technology, 2004
- Electrical low pressure impactorJournal of Aerosol Science, 1992
- Adsorption of Gases in Multimolecular LayersJournal of the American Chemical Society, 1938