Ultrastable optical components using adjustable commercial mirror mounts anchored in a ULE spacer
- 10 August 2020
- journal article
- research article
- Published by Optica Publishing Group in Applied Optics
- Vol. 59 (23), 6999-7003
- https://doi.org/10.1364/AO.395831
Abstract
This paper describes a novel, to the best of our knowledge, approach to build ultrastable interferometers using commercial mirror mounts anchored in an ultralow expansion (ULE) base. These components will play a critical role in any light particle search (ALPS) and will also be included in ground testing equipment for the upcoming laser interferometer space antenna (LISA) mission. Contrary to the standard ultrastable designs where mirrors are bonded to the spacers, ruling out any later modifications and alignments, our design remains flexible and allows the alignment of optical components at all stages to be optimized and changed. Here we present the dimensional stability and angular stability of two commercial mirror mounts characterized in a cavity setup. The long-term length change in the cavity did not exceed 30 nm and the relative angular stability was within 2 mu rad, which meet the requirements for ALPS. We were also able to demonstrate 1 pm/root Hz length noise stability, which is a critical requirement for various subsystems in LISA. These results have led us to design similar opto-mechanical structures, which will be used in ground verification to test the LISA telescope. (C) 2020 Optical Society of AmericaFunding Information
- National Science Foundation (PHY-1505743, PHY-1802006)
- National Aeronautics and Space Administration (80NSSC18K0552)
This publication has 11 references indexed in Scilit:
- Coherent detection of ultraweak electromagnetic fieldsPhysical Review D, 2019
- LISA Pathfinder: First steps to observing gravitational waves from spaceJournal of Physics: Conference Series, 2017
- High-Performance Optical Frequency References for SpaceJournal of Physics: Conference Series, 2016
- Heterodyne laser frequency stabilization for long baseline optical interferometry in space-based gravitational wave detectorsPhysical Review D, 2015
- Ultrastable, Zerodur-based optical benches for quantum gas experimentsApplied Optics, 2014
- Hydroxide catalysis bonding for astronomical instrumentsAdvanced Optical Technologies, 2014
- Note: Silicon carbide telescope dimensional stability for space-based gravitational wave detectorsReview of Scientific Instruments, 2012
- LIGO: the Laser Interferometer Gravitational-Wave ObservatoryReports on Progress in Physics, 2009
- An introduction to Pound–Drever–Hall laser frequency stabilizationAmerican Journal of Physics, 2001
- Längenstabilität bei Raumtemperatur von Proben der Glaskeramik "Zerodur"Metrologia, 1985