High-Repetition-Rate and High-Beam-Quality Laser Pulses with 1.5MW Peak Power Generation from a Two-Stage Nd:YVO4 Amplifier*
- 1 November 2019
- journal article
- research article
- Published by IOP Publishing in Chinese Physics Letters
- Vol. 36 (11)
- https://doi.org/10.1088/0256-307x/36/11/114202
Abstract
We develop a two-stage end-pumped Nd:YVO4 amplifier seeded by a passively Q-switched microchip laser. An average output power of 13.5 W with repetition rate up to 7 kHz and pulse duration of ∼1.24 ns is obtained, corresponding to a pump extraction efficiency of 16.1% (19.5% for the second stage) and peak power of ∼1.5 MW. The beam quality factors at maximum output power are measured to be M x 2 = 1.56 and M y 2 = 1.48 . We introduce an analytical model to estimate gain and beam quality after amplification. This model focuses on the influence of ratio of seed spot radius to pump spot radius when designing an amplifier. Moreover, our experiments reveal that the re-imaging system in the double-pass configuration can be used to enhance the beam quality.Keywords
This publication has 18 references indexed in Scilit:
- High-Efficiency 2-mJ 5-kHz Picosecond Green Laser Generation by Nd:YAG Innoslab AmplifierIEEE Photonics Technology Letters, 2015
- Efficient high-quality picosecond Nd:YVO_4bounce laser systemJournal of the Optical Society of America B, 2013
- Design of a high gain single stage and single pass Nd:YVO_4 passive picosecond amplifierJournal of the Optical Society of America B, 2012
- Gain guiding effect in end-pumped Nd:YVO_4 MOPA lasersJournal of the Optical Society of America B, 2010
- Temperature-dependent stimulated emission cross section in Nd^3+:YVO_4 crystalsJournal of the Optical Society of America B, 2009
- Thermal effects and their mitigation in end-pumped solid-state lasersJournal of Physics D: Applied Physics, 2001
- Determination of the Auger upconversion rate in fiber-coupled diode end-pumped Nd:YAG and Nd:YVO 4 crystalsApplied Physics B Laser and Optics, 2000
- Analysis of laser beam quality degradation caused by quartic phase aberrationsApplied Optics, 1993
- Thermal modeling of continuous-wave end-pumped solid-state lasersApplied Physics Letters, 1990