The application of hardened steel parts for the purpose of wear-resistance increase becomes increasing spread in different branches of mechanical engineering. In view of high hardness of the work surface of parts, finishing is carried out by flat grinding. During the hardened steel grinding there are formed burns, cracks, admixtures of abrasive particles in the work surface which are inadmissible defects in a surface layer of critical parts mounted in the fuel unit of an aviation engine. The analysis of literature and company experience has shown that after thermal treatment instead of finishing is necessary to use surface finishing by a face milling method, but there are no sufficient recommendations for tool choice and cutting modes to date. Jointly with the educational department there are carried out theoretical researches of cutters for the face milling of the “selector housing” mass-produced parts consisting of corrosion-resistant 95H18-Sh steel with the hardness of 59÷61 HRC. In the paper there is considered a chemical composition of 95H18-Sh steel, a method for manufacturing a cast, its physical, mechanical and chemical properties. Taking into account data obtained for the face-milling cutter installation on the frame there was chosen Sandvik Coromant material for the replaceable cutting insert the base of which consists of hard alloy 1010 with PVD coating. Later on there was carried out selection of basic geometrical parameters and characteristics of a cutting plate and also a micro-geometry of a major cutting edge and a tip. Mass-produced replaceable through-away plates with R245-12 T3 M-PM number of 1010 hard alloy and PVD coating were obtained from the catalog of Sandvik Coromant company. At the end of the work a conclusion was drawn that the application of face milling will allow ensuring the requirements to the design documentation of the product, decreasing thermal and power stress of the process, increasing productivity, surface quality and excluding the necessity in abrasion, and the investigation results are applicable to the fulfillment of the complete factor experiment and computation of a simulator with the definition of the impact of variable factors upon a response function.