Evaluation of activated corrosion products in primary coolant circuit of AP-1000 under grid frequency stability mode
- 30 October 2018
- journal article
- research article
- Published by Elsevier BV in Annals of Nuclear Energy
- Vol. 125, 138-147
- https://doi.org/10.1016/j.anucene.2018.10.031
Abstract
No abstract availableKeywords
Funding Information
- CSC (2016GXZO22)
This publication has 15 references indexed in Scilit:
- Evaluation of Corrosion Product Activity in a Typical PWR with Extended Cycles and Flow Rate PerturbationsWorld Journal of Nuclear Science and Technology, 2017
- Calculation of Radioactivity and Dose Rate of Activated Corrosion Products in Water-Cooled Fusion ReactorScience and Technology of Nuclear Installations, 2016
- Adaptive coupled synchronization among three coupled chaos systems and its application to secure communicationsEURASIP Journal on Wireless Communications and Networking, 2016
- PWR circuit contamination assessment tool. Use of OSCAR code for engineering studies at EDFEPJ Nuclear Sciences & Technologies, 2016
- Development of a simulation platform for studying on primary frequency regulation characteristics of nuclear unitsProgress in Nuclear Energy, 2014
- Time-dependent corrosion product activity in a typical PWR due to changes in coolant chemistry for long-term fuel cyclesProgress in Nuclear Energy, 2012
- Static and dynamic sensitivity analysis of corrosion product activity in primary coolant circuits of pressurized water reactorsProgress in Nuclear Energy, 2010
- Computer simulation of corrosion product activity in primary coolants of a typical PWR under flow rate transients and linearly accelerating corrosionAnnals of Nuclear Energy, 2003
- Modeling and simulation of corrosion product activity in pressurized water reactors under power perturbationsAnnals of Nuclear Energy, 1999
- Simulation of corrosion product activity in pressurized water reactors under flow rate transientsAnnals of Nuclear Energy, 1998