Lumped-Parameter Response Time Models for Pneumatic Circuit Dynamics
- 18 November 2020
- journal article
- research article
- Published by ASME International in Journal of Dynamic Systems, Measurement, and Control
- Vol. 143 (5)
- https://doi.org/10.1115/1.4049009
Abstract
Resistor–capacitor (RC) response time models for pressurizing and depressurizing a pneumatic capacitor (mass accumulator) through a resistor (flow restriction) comprise a framework to systematically analyze complex fluidic circuits. A model for pneumatic resistance is derived from a combination of fundamental fluid mechanics and experimental results. Models describing compressible fluid capacitance are derived from thermodynamic first principles and validated experimentally. The models are combined to derive the ordinary differential equations that describe the RC dynamics. These equations are solved analytically for rigid capacitors and numerically for deformable capacitors to generate pressure response curves as a function of time. The dynamic pressurization and depressurization response times to reach 63.2% (or 1−e−1) of exponential decay are validated in simple pneumatic circuits with combinations of flow restrictions ranging from 100 μm to 1 mm in diameter, source pressures ranging from 5 to 200 kPa, and capacitor volumes of 0.5 to 16 mL. Our RC models predict the response times, which range from a few milliseconds to multiple seconds depending on the combination, with a coefficient of determination of r2=0.983. The utility of the models is demonstrated in a multicomponent fluidic circuit to find the optimal diameter of tubing between a three-way electromechanical valve and a pneumatic capacitor to minimize the response time for the changing pressure in the capacitor. These lumped-parameter models represent foundational blocks upon which timing models of pneumatic circuits can be built for a variety of applications from soft robotics and industrial automation to high-speed microfluidics.Keywords
This publication has 18 references indexed in Scilit:
- Analogy among microfluidics, micromechanics, and microelectronicsLab on a Chip, 2013
- Integrated elastomeric components for autonomous regulation of sequential and oscillatory flow switching in microfluidic devicesNature Physics, 2010
- Static control logic for microfluidic devices using pressure-gain valvesNature Physics, 2010
- Modulation of fluidic resistance and capacitance for long-term, high-speed feedback control of a microfluidic interfaceLab on a Chip, 2009
- Frequency-specific flow control in microfluidic circuits with passive elastomeric featuresNature Physics, 2009
- Microfluidic bypass for efficient passive regulation of droplet traffic at a junctionApplied Physics Letters, 2006
- Microfluidics: Fluid physics at the nanoliter scaleReviews of Modern Physics, 2005
- A Microfluidic Rectifier: Anisotropic Flow Resistance at Low Reynolds NumbersPhysical Review Letters, 2004
- Microfluidic Large-Scale IntegrationScience, 2002
- Modeling micropumps with electrical equivalent networksJournal of Micromechanics and Microengineering, 1996