FABRICATION OF UNILATERAL OVER DENTURE WITH COMBINATION HORIZONTAL RETENTION AND VERTICAL ATTACHMENT (LABORATORY PROCEDURES)
Open Access
- 10 September 2019
- journal article
- Published by Universitas Airlangga in Journal Of Vocational Health Studies
- Vol. 3 (1), 11-16
- https://doi.org/10.20473/jvhs.v3.i1.2019.11-16
Abstract
Background: Currently, there is a lot of design attachment, and every design has a different laboratory procedure. One of them is retention combination horizontal and vertical synchronization. Purpose: to know the process of making a unilateral overdenture with combination horizontal and vertical attachment (laboratory procedure). Reviews: Overdenture is artificial tooth receives support and the retention of one or more teeth an abutment or receives the support of an implant. Attachment is a connector owned two or more parts. One part connected with a root, teeth, or implant while the other part connected to protesa. Unilateral over denture is artificial tooth some off who just made was on the side of the jaw just. Conclusion: The manufacture of unilateral overdenture retention combination with horizontal and vertical synchronization attachment in the laboratory has many steps.Keywords
This publication has 4 references indexed in Scilit:
- Precision attachments in partial removable prosthodontics: an update for the practitioner part 1Dental Update, 2014
- Combined Prosthesis with Extracoronal Castable Precision AttachmentsCase Reports in Dentistry, 2013
- Retention of Implant-Supported Overdenture With Bar/Clip and Stud Attachment DesignsJournal of Oral Implantology, 2013
- Attachment-retained Unilateral Distal Extension (Kennedy's Class II Modification I) Cast Partial DentureInternational Journal of Prosthodontics and Restorative Dentistry, 2012