Reducing the Energy and Steam Consumption of SAGD Through Cyclic Solvent Co-Injection
Open Access
- 12 October 2019
- Vol. 12 (20), 3860
- https://doi.org/10.3390/en12203860
Abstract
The amount of oil that is contained in the Canadian oil sands represent the third largest oil accumulation in the world. Approximately half of the daily oil production from the oil sands comes from mining processes and the other half is produced mostly using steam assisted gravity drainage (SAGD). This method is effective at reducing the viscosity of the oil. However, the generation of steam requires a significant amount of energy. Thus, there is an ongoing effort to reduce the energy needed to produce oil from the oil sands. In this article the intermittent injection of a solvent, along with steam, is investigated as a means of reducing the amount of energy required to extract oil from the Canadian oil sands. A simulation-based study examined the effect of the type of solvent, the cycles’ duration, the solvent concentration and the number of cycles. The simulations covered a time span of 10 years during which several different solvents (methane, ethane, propane, butane, pentane, hexane, and CO2) were injected under varying injection schedules. The solvents that were investigated are compounds that are likely to be readily available at a heavy oil production site. The solvent injection periods ranged from six to 24 months in length. The results reveal that SAGD combined with intermittent injection of hexane resulted in the most significant improvement to the cumulative oil production and in the cumulative energy-oil ratio (cEOR). Compared to SAGD without solvent injection, the cumulative oil production was increased by 45% and the cEOR was reduced by 23%. It was also seen that the performance of the proposed process is highly dependent on the resulting physical properties of the solvent-bitumen mixture. Finally, a simplified economic analysis also identified SAGD with intermittent hexane injection as the scheme that resulted in the highest net present value. Compared to SAGD without solvent injection, the intermittent injection of hexane led to an 85% increase in the net present value.This publication has 23 references indexed in Scilit:
- Energy efficiency and emissions intensity of SAGDFuel, 2014
- Predicting Water‐Hydrocarbon Systems Mutual SolubilityChemical Engineering & Technology, 2008
- Design of the Steam and Solvent Injection Strategy in Expanding Solvent Steam-Assisted Gravity DrainageJournal of Canadian Petroleum Technology, 2008
- Oil phase viscosity behaviour in Expanding-Solvent Steam-Assisted Gravity DrainageJournal of Petroleum Science and Engineering, 2007
- Fast-SAGD Application in the Alberta Oil Sands AreasJournal of Canadian Petroleum Technology, 2006
- Novel Expanding Solvent-SAGD Process "ES-SAGD"Journal of Canadian Petroleum Technology, 2003
- A Canadian Perspective On In Situ CombustionJournal of Canadian Petroleum Technology, 1999
- The Steam And Gas Push (SAGP)Journal of Canadian Petroleum Technology, 1999
- A New Process (VAPEX) For Recovering Heavy Oils Using Hot Water And Hydrocarbon VapourJournal of Canadian Petroleum Technology, 1991
- Viscosity of crude oilsChemical Engineering Science, 1984