Electrochemical and mechanical performance of reduced graphene oxide, conductive hydrogel, and electrodeposited Pt-Ir coated electrodes: an active in vitro study
- 1 February 2020
- journal article
- research article
- Published by IOP Publishing in Journal of Neural Engineering
- Vol. 17 (1), 016015
- https://doi.org/10.1088/1741-2552/ab5163
Abstract
Objective. To systematically compare the in vitro electrochemical and mechanical properties of several electrode coatings that have been reported to increase the efficacy of medical bionics devices by increasing the amount of charge that can be delivered safely to the target neural tissue. Approach. Smooth platinum (Pt) ring and disc electrodes were coated with reduced graphene oxide, conductive hydrogel, or electrodeposited Pt-Ir. Electrodes with coatings were compared with uncoated smooth Pt electrodes before and after an in vitro accelerated aging protocol. The various coatings were compared mechanically using the adhesion-by-tape test. Electrodes were stimulated in saline for 24 hours/day 7 days/week for 21 d at 85 degrees C (1.6-year equivalence) at a constant charge density of 200 mu C/cm(2)/phase. Electrodes were graded on surface corrosion and trace analysis of Pt in the electrolyte after aging. Electrochemical measurements performed before, during, and after aging included electrochemical impedance spectroscopy, cyclic voltammetry, and charge injection limit and impedance from voltage transient recordings. Main results. All three coatings adhered well to smooth Pt and exhibited electrochemical advantage over smooth Pt electrodes prior to aging. After aging, graphene coated electrodes displayed a stimulation-induced increase in impedance and reduction in the charge injection limit (p < 0.001), alongside extensive corrosion and release of Pt into the electrolyte. In contrast, both conductive hydrogel and Pt-Ir coated electrodes had smaller impedances and larger charge injection limits than smooth Pt electrodes (p < 0.001) following aging regardless of the stimulus level and with little evidence of corrosion or Pt dissolution. Significance. This study rigorously tested the mechanical and electrochemical performance of electrode coatings in vitro and provided suitable candidates for future in vivo testing.Funding Information
- National Health and Medical Research Council (APP1122055)
- Garnett Passe and Rodney Williams Memorial Foundation
This publication has 60 references indexed in Scilit:
- Conductive Hydrogels: Mechanically Robust Hybrids for Use as BiomaterialsMacromolecular Bioscience, 2012
- Use of a Bayesian maximum-likelihood classifier to generate training data for brain–machine interfacesJournal of Neural Engineering, 2011
- Direct electro-deposition of graphene from aqueous suspensionsPhysical Chemistry Chemical Physics, 2011
- Poly(3,4-ethylenedioxythiophene) (PEDOT) polymer coatings facilitate smaller neural recording electrodesJournal of Neural Engineering, 2011
- Electrodeposition and Characterization of Thin-Film Platinum-Iridium Alloys for Biological InterfacesJournal of the Electrochemical Society, 2011
- Prototype to product—developing a commercially viable neural prosthesisJournal of Neural Engineering, 2009
- Polypyrrole-coated electrodes for the delivery of charge and neurotrophins to cochlear neuronsBiomaterials, 2009
- In Vivo Electrical Impedance Spectroscopy of Tissue Reaction to Microelectrode ArraysIEEE Transactions on Biomedical Engineering, 2009
- Sputtered iridium oxide films for neural stimulation electrodesJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2008
- Scanning electron microscopy of chronically stimulated platinum intracochlear electrodesBiomaterials, 1985