VOC Emissions and Formation Mechanisms from Carbon Nanotube Composites during 3D Printing
- 15 March 2019
- journal article
- research article
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 53 (8), 4364-4370
- https://doi.org/10.1021/acs.est.9b00765
Abstract
A commercially available, 3D printer nanocomposite filament of carbon nanotubes (CNTs) and acrylonitrile–butadiene–styrene (ABS) was analyzed with respect to its VOC emissions during simulated fused deposition modeling (FDM) and compared with a regular ABS filament. VOC emissions were quantified and characterized under a variety of conditions to simulate the thermal degradation that takes place during FDM. Increasing the residence time and temperature resulted in significant increases in VOC emissions, and the oxygen content of the reaction gas influenced the VOC profile. In agreement with other studies, the primary emitted VOC was styrene. Multiple compounds are reported in this work for the first time as having formed during FDM, including 4-vinylcyclohexene and 2-phenyl-2-propanol. Our results show that printing 222.0 g of filament is enough to surpass the reference concentration for inhalation exposure of 1 mg/m3 according to the EPA’s Integrated Risk Information System (IRIS). The presence of CNTs in the filament influenced VOC yields and product ratios through three types of surface interactions: (1) adsorption of O2 on CNTs lowers the available O2 for oxidation of primary backbone cleavage intermediates, (2) adsorption of styrene and other VOCs to CNTs leads to surface-catalyzed degradation, and (3) CNTs act as a trap for certain VOCs and prevent them from entering vapor emissions. While the presence of CNTs in the filament lowered the total VOC emission under most experimental conditions, they increased the emission of the most hazardous VOCs, such as α-methylstyrene and benzaldehyde. The present study has identified an increased risk associated with the use of CNT nanocomposites in 3D printing.Keywords
Funding Information
- Oak Ridge Institute for Science and Education (92431601)
- U.S. Environmental Protection Agency
This publication has 32 references indexed in Scilit:
- Molecular Products and Radicals from Pyrolysis of LigninEnvironmental Science & Technology, 2012
- Carbon nanotubes as adsorbents in environmental pollution management: A reviewChemical Engineering Journal, 2011
- Adsorption of Aromatic Compounds by Carbonaceous Adsorbents: A Comparative Study on Granular Activated Carbon, Activated Carbon Fiber, and Carbon NanotubesEnvironmental Science & Technology, 2010
- Degradation behavior and kinetic study of ABS polymerJournal of Thermal Analysis and Calorimetry, 2009
- Adsorption of Phenolic Compounds by Carbon Nanotubes: Role of Aromaticity and Substitution of Hydroxyl GroupsEnvironmental Science & Technology, 2008
- Small but strong: A review of the mechanical properties of carbon nanotube–polymer compositesCarbon, 2006
- Big returns from small fibers: A review of polymer/carbon nanotube compositesPolymer Composites, 2004
- Thermal analysis of an acrylonitrile–butadiene–styrene/SWNT compositePolymer Degradation and Stability, 2004
- SUBACUTE INHALATION TOXICITY OF BENZALDEHYDE IN THE SPRAGUE-DAWLEY RATAihaj Journal, 1991
- Gas chromatographic—mass spectrometric analysis of some potential toxicants amongst volatile compounds emitted during large-scale thermal degradation of poly(acrylonitrile—butadiene—styrene) plasticJournal of Chromatography B: Biomedical Sciences and Applications, 1991