Effect of laser remelting on surface roughness and microstructure of AlSi10Mg selective laser melting manufactured parts
- 24 February 2021
- journal article
- research article
- Published by Springer Science and Business Media LLC in The International Journal of Advanced Manufacturing Technology
- Vol. 113 (9-10), 2739-2759
- https://doi.org/10.1007/s00170-021-06775-3
Abstract
No abstract availableKeywords
This publication has 33 references indexed in Scilit:
- Roughness modeling of AlSi10Mg parts fabricated by selective laser meltingJournal of the American Academy of Dermatology, 2017
- Selective laser melting of AlSi10Mg: Effects of scan direction, part placement and inert gas flow velocity on tensile strengthJournal of the American Academy of Dermatology, 2017
- On the Selective Laser Melting (SLM) of the AlSi10Mg Alloy: Process, Microstructure, and Mechanical PropertiesMaterials, 2017
- Influence of the shielding gas flow on the removal of process by-products in the selective laser melting processAdditive Manufacturing, 2016
- On the effect of process parameters on properties of AlSi10Mg parts produced by DMLSRapid Prototyping Journal, 2014
- Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powderActa Materialia, 2013
- Influence of process parameters on surface roughness of aluminum parts produced by DMLSThe International Journal of Advanced Manufacturing Technology, 2012
- Gas flow effects on selective laser melting (SLM) manufacturing performanceJournal of the American Academy of Dermatology, 2011
- Balling behavior of stainless steel and nickel powder during selective laser melting processThe International Journal of Advanced Manufacturing Technology, 2011
- The investigation of the influence of laser re‐melting on density, surface quality and microstructure of selective laser melting partsRapid Prototyping Journal, 2011