Tensile fracture behavior of 316L stainless steel components fabricated with hybrid directed energy deposition and thermal milling manufacturing
- 26 February 2021
- journal article
- research article
- Published by Springer Science and Business Media LLC in Applied Physics A
- Vol. 127 (3), 1-10
- https://doi.org/10.1007/s00339-021-04381-4
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (51875265, 51775250)
This publication has 40 references indexed in Scilit:
- Investigation of part distortions as a result of hybrid manufacturingRobotics and Computer-Integrated Manufacturing, 2016
- Hybrid additive and subtractive machine tools - Research and industrial developmentsInternational Journal of Machine Tools and Manufacture, 2016
- Characterization of heat affected zone liquation cracking in laser additive manufacturing of Inconel 718Materials & Design, 2016
- Effects of process time interval and heat treatment on the mechanical and microstructural properties of direct laser deposited 316L stainless steelMaterials Science and Engineering: A, 2015
- Additive Manufacturing of IN100 Superalloy Through Scanning Laser Epitaxy for Turbine Engine Hot-Section Component Repair: Process Development, Modeling, Microstructural Characterization, and Process ControlMetallurgical and Materials Transactions, 2015
- Additive manufacturing of strong and ductile Ti–6Al–4V by selective laser melting via in situ martensite decompositionActa Materialia, 2014
- An Experimental Investigation into Additive Manufacturing-Induced Residual Stresses in 316L Stainless SteelMetallurgical and Materials Transactions, 2014
- Microstructural and mechanical characteristics of laser welding of Ti6Al4V and lead metalJournal of the American Academy of Dermatology, 2012
- Laser welding of Ti6Al4V titanium alloysJournal of the American Academy of Dermatology, 2009
- Cutting temperature, tool wear, surface roughness and dimensional deviation in turning AISI-4037 steel under cryogenic conditionInternational Journal of Machine Tools and Manufacture, 2007