Influence of the Microstructure of Cutting Ceramics on the Efficiency of the Machining Process
- 27 July 2021
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1040, 21-27
- https://doi.org/10.4028/www.scientific.net/msf.1040.21
Abstract
The article deals with the determination of the efficiency of a multi-bladed tool equipped with inserts made of oxide-carbide cutting ceramics, depending on the microstructural parameters of the tool material. The microstructural parameters of the oxide-carbide cutting ceramic, which affect the performance of the tool, are proposed to be determined according to the electrical resistance of the tool material. In order to implement the method for determining the working capacity of the instrument, a basic design of the device for measuring the electrical resistance of the material of the instrument is proposed. The device for measuring the electrical resistance of ceramic plates consists of a body made of a dielectric material, with channels for supplying a conductive material and a groove for installing a case with a test sample. During the test, the channels are filled with a liquid conductive material, which fills the cavity formed by the channel of the case, the groove of the case and the plate itself under test. To ensure uniform filling of the cavity, after the introduction of the liquid conductive material, metal balls are installed into the channels, which are made in such a size as to ensure free sliding along the channel, but not to let the liquid pass into the upper part of the channel. The tested ceramic plate is installed in the walls of the removable case. The walls of the removable case include electrodes, which, when the device is in operation, are inserted into a cavity with a liquid conductive material at one end, and are connected to an ohmmeter at the other. Using a device for measuring the electrical resistance of ceramic plates, it is possible to determine the operability of the tool and guarantee its operation without rejection for a certain period of time, which was confirmed by experimental research in the milling of workpieces of machine parts made of gray cast iron. Experimental studies in multi-edge machining with cutters with different values of electrical resistance of ceramic plates made it possible to plot graphs of the dependence of the quality of machining during milling on the operability of the tool and on the time of the machining process.This publication has 13 references indexed in Scilit:
- Vibration Amplitude and Frequency Parameters of Technological Equipment DrivesProceedings of International Scientific Conference on Telecommunications, Computing and Control, 2020
- Detection of Intermediate Phases in Metal AlloysKey Engineering Materials, 2020
- Improving the efficiency of technological preparation of single and small batch production based on simulation modelingJournal of Mining Institute, 2019
- Oil and gas sector products cold working processPublished by Taylor & Francis Ltd ,2019
- Determination of technological residual stresses in the surface layer of parts with thin-walled elements during turningIOP Conference Series: Materials Science and Engineering, 2019
- Creating a model of diffusion deposition of metal coatings from melts of low-melting metalsIOP Conference Series: Materials Science and Engineering, 2019
- Precision dimensional analysis in CAD design of reliable technologiesIOP Conference Series: Earth and Environmental Science, 2018
- Manufacturing and Design Technology of Combined Corrected Gearing and Non-Standard Radial ClearanceIOP Conference Series: Earth and Environmental Science, 2018
- Analysis of Cambrian clay cutting during Saint-Petersburg subway constructionGornyi Zhurnal, 2018
- Сomputer Simulation of MachiningKey Engineering Materials, 2017