Orta tabakası kompost atığı ilaveli yongalevhaların vida tutma gücü ve ısı iletkenlik değerlerinin belirlenmesi
Open Access
- 15 October 2017
- journal article
- Published by Artvin Coruh Universitesi Orman Fakultesi Dergisi in Artvin Çoruh Üniversitesi Orman Fakültesi Dergisi
- Vol. 18 (2), 1-9
- https://doi.org/10.17474/artvinofd.320521
Abstract
En tr In is study, screw holding and thermal conductivity values of particleboard produced from wood and compost waste were investigated under the laboratory conditions. To that end, the compost waste and industrial wood chips were used to a certain extent in the core layer while only industrial wood chips were used in the surface layers. Particleboard produced in 50x50x1.8 cm dimensions, at 0.630 g cm-3 density with using 50% urea formaldehyde adhesive. The surface and edge vertical screw holding and thermal conductivity of particleboards were determined. It was stated that addition of compost waste affected the surface and edge vertical screw holding of particleboard. The thermal conductivity values belonging to particleboard were found to vary between 0.086-0.120 W m-1°K-1. The best results for the insulation board were obtained from the particleboard using 100% compost waste in the core layer. Bu çalışmada laboratuvar ortamında odun ve kompost atıklarından üre formaldehit tutkalı kullanılarak üretilen yongalevhaların vida tutma gücü ve ısı iletkenlik değerleri araştırılmıştır. Bu amaçla, dış tabakada sadece endüstriyel odun yongası kullanılır iken orta takada ise belli oranlarda kompost atığı ve endüstriyel odun yongası karışımı kullanılmıştır. Levha yoğunluğu 0.630 g cm-3 olan, 50x50x1.8 cm boyutlarında, %50’lik üre formaldehit tutkalı kullanılarak yatık preslenmiş yongalevhalar üretilmiştir. Levhaların yüzeylerine ve kenarlarına dik vida tutma gücü ile ısı iletkenlik değerleri belirlenmiştir. Kompost atığı ilavesinin, yongalevhaların yüzeyine dik ve paralel yöndeki vida tutma gücü değerleri üzerine etkili olduğu saptanmıştır. Levha gruplarına ait ısı iletkenlik değerleri 0.086-0.120 W m-1°K-1 arasında değiştiği tespit edilmiştir. İzolasyon levhası olarak en iyi sonuçlar orta tabakasında %100 kompost atığı kullanılan yongalevhalarda elde edilmiştir.Keywords
This publication has 3 references indexed in Scilit:
- Construction particleboards made from rapeseed straw glued with hybrid pMDI/PF resinEuropean Journal of Wood and Wood Products, 2016
- Effect of Particle Size and Geometry on the Performance of Single-layer and Three-layer Particleboard Made from Sunflower Seed HusksBioResources, 2014
- The potential use of Ricinus communis L. (Castor) stalks as a lignocellulosic resource for particleboardsIndustrial Crops and Products, 2001