3D Modeling of Mine Protection Complex Steel Structure Based on BIM Technology
Open Access
- 6 March 2023
- journal article
- research article
- Published by Hindawi Limited in Journal of Applied Mathematics
- Vol. 2023, 1-9
- https://doi.org/10.1155/2023/7193935
Abstract
The objective of this paper is to study the antidamage ability of beam column joints in complex steel structures under external forces and to improve the safety of such structures. In this study, a three-dimensional model of complex steel structure based on BIM technology is proposed by analyzing and calculating the ultimate strength of complex steel structure for mine protection. The vibration control algorithm of complex steel structure for mine protection is designed, and the boundary elastic constraint conditions are determined. According to the constraint conditions, the vibration characteristics of complex steel structures for mining are analyzed. The experimental results show that the maximum displacement of the design model is reduced by half compared with that before optimization, which can meet the design requirements.Keywords
Funding Information
- Zhejiang Provincial Construction Scientific Research Project (2020K203)
This publication has 19 references indexed in Scilit:
- Radon Exposures of Miners at Small Underground Construction Sites in Old Mining: Recommendations to Improve Radiation Protection Measures by the Saxon Radiation Protection AuthorityHealth Physics, 2019
- A comparative analysis of driving force models for fatigue crack propagation of CFRP-reinforced steel structureInternational Journal of Fatigue, 2019
- Finite element analysis for rockfall and debris flow mitigation worksCanadian Geotechnical Journal, 2019
- Single-story steel structure with LVEM-isolated floor: Elastic seismic performance and design response spectrumEngineering Structures, 2019
- Solidification Structure, Non-metallic Inclusions and Hot Ductility of Continuously Cast High Manganese TWIP Steel SlabISIJ International, 2019
- Cutting Forces, Surface Roughness and Tool Wear Quality Assessment Using ANN and PSO Approach During Machining of MDN431 with TiN/AlN-Coated Cutting ToolArabian Journal for Science and Engineering, 2019
- A Sequential Optimality Condition Related to the Quasi-normality Constraint Qualification and Its Algorithmic ConsequencesSIAM Journal on Optimization, 2019
- Tribological behaviour of monolayer and multilayer Ti-based thin solid films deposited on alloy steelMaterials Research Express, 2018
- Effect of cutting parameters on tool wear, cutting force and surface roughness in machining of MDN431 alloy using Al and Fe coated toolsMaterials Research Express, 2018
- Development and Characterization of Ti/TiC/TiN Coatings by Cathodic Arc Evaporation TechniqueTransactions of the Indian Institute of Metals, 2017