New Search

Export article

Analisis Ketepatan Pengukur Daya dan Faktor Daya Listrik Berbasis Arduino Uno R3 328P

Wilda Noer Agustianingsih, Freddy Kurniawan, Paulus Setiawan
Published: 17 November 2020
AVITEC , Volume 3; doi:10.28989/avitec.v3i1.794

Abstract: Electric power and power factor are two parameters that must be considered because they involve the quality of the energy consumed. In order to be able to analyze these, a microcontroller-based power and power factor meter are needed which can be further developed. In this research, a power and power factor meter based on the ATmega328P microcontroller was developed on the Arduino board. Several algorithms are used to calculate the frequency of the grids, as well as the true-RMS of voltage and current. The simulation results show that this system can measure the power and power factor for input voltages of 100 to 300 volts with a frequency of 45 to 156 Hz for loads up to 5 amperes. The mean calculation average error for linear load is 0.28% for active power and -0.33% for apparent power. Meanwhile, for nonlinear loads, the calculation average error for active power is 1.86% and apparent power is 0.47%.
Keywords: Arduino / power factor / microcontroller / frequency / average / Voltage / meter / Loads / Daya / Power and Power

Scifeed alert for new publications

Never miss any articles matching your research from any publisher
  • Get alerts for new papers matching your research
  • Find out the new papers from selected authors
  • Updated daily for 49'000+ journals and 6000+ publishers
  • Define your Scifeed now

Share this article

Click here to see the statistics on "AVITEC" .
Back to Top Top