Prediction of residual stress and deformation based on the temperature distribution in 3D-printed parts
- 19 February 2021
- journal article
- research article
- Published by Springer Science and Business Media LLC in The International Journal of Advanced Manufacturing Technology
- Vol. 113 (7-8), 2227-2242
- https://doi.org/10.1007/s00170-021-06711-5
Abstract
No abstract availableKeywords
This publication has 22 references indexed in Scilit:
- Selective laser melting of Ti6Al4V alloy for biomedical applications: Temperature monitoring and microstructural evolutionJournal of Alloys and Compounds, 2014
- Simulation of Laser Beam Melting of Steel Powders using the Three-Dimensional Volume of Fluid MethodPhysics Procedia, 2013
- Factor analysis of selective laser melting process parameters and geometrical characteristics of synthesized single tracksRapid Prototyping Journal, 2012
- Process parameter selection for selective laser melting of Ti6Al4V based on temperature distribution simulation and experimental sinteringThe International Journal of Advanced Manufacturing Technology, 2011
- Densification behavior of gas and water atomized 316L stainless steel powder during selective laser meltingApplied Surface Science, 2010
- Analytical and numerical modelling of the direct metal deposition laser processJournal of Physics D: Applied Physics, 2008
- Residual stresses in selective laser sintering and selective laser meltingRapid Prototyping Journal, 2006
- Temperature measurements during selective laser sintering of titanium powderInternational Journal of Machine Tools and Manufacture, 2004
- RAPID MANUFACTURING AND RAPID TOOLING WITH LAYER MANUFACTURING (LM) TECHNOLOGIES, STATE OF THE ART AND FUTURE PERSPECTIVESCIRP Annals, 2003
- Sintering of commercially pure titanium powder with a Nd:YAG laser sourceActa Materialia, 2003