Diamond-Coated Plasma Probes for Hot and Hazardous Plasmas
Open Access
- 13 October 2020
- Vol. 13 (20), 4524
- https://doi.org/10.3390/ma13204524
Abstract
Plasma probes are simple and inexpensive diagnostic tools for fast measurements of relevant plasma parameters. While in earlier times being employed mainly in relatively cold laboratory plasmas, plasma probes are now routinely used even in toroidal magnetic fusion experiments, albeit only in the edge region, i.e., the so-called scrape-off layer (SOL), where temperature and density of the plasma are lower. To further avoid overheating and other damages, in medium-size tokamak (MST) probes are inserted only momentarily by probe manipulators, with usually no more than a 0.1 s per insertion during an average MST discharge of a few seconds. However, in such hot and high-density plasmas, their usage is limited due to the strong particle fluxes onto the probes and their casing which can damage the probes by sputtering and heating and by possible chemical reactions between plasma particles and the probe material. In an attempt to make probes more resilient against these detrimental effects, we tested two graphite probe heads (i.e., probe casings with probes inserted) coated with a layer of electrically isolating ultra-nano-crystalline diamond (UNCD) in the edge plasma region of the Experimental Advanced Superconducting Tokamak (EAST) in Hefei, People’s Republic of China. The probe heads, equipped with various graphite probe pins, were inserted frequently even into the deep SOL up to a distance of 15 mm inside the last closed flux surface (LCFS) in low- and high-confinement regimes (L-mode and H-mode). Here, we concentrate on results most relevant for the ability to protect the graphite probe casings by UNCD against harmful effects from the plasma. We found that the UNCD coating also prevented almost completely the sputtering of graphite from the probe casings and thereby the subsequent risk of re-deposition on the boron nitride isolations between probe pins and probe casings by a layer of conductive graphite. After numerous insertions into the SOL, first signs of detachment of the UNCD layer were noticed.This publication has 27 references indexed in Scilit:
- A Probe Head for Simultaneous Measurements of Electrostatic and Magnetic Fluctuations in ASDEX Upgrade Edge PlasmaContributions to Plasma Physics, 2010
- Raman Studies of Nano‐ and Ultra‐nanocrystalline Diamond Films Grown by Hot‐Filament CVDChemical Vapor Deposition, 2010
- Generation of blobs and holes in the edge of the ASDEX Upgrade tokamakPlasma Physics and Controlled Fusion, 2010
- Blob/hole formation and zonal-flow generation in the edge plasma of the JET tokamakNuclear Fusion, 2009
- Direct Measurement of Current Filament Structures in a Magnetic-Confinement Fusion DevicePhysical Review Letters, 2009
- Modelling the Influence of the Nucleation Density on Ultra Nano Crystalline Diamond Growth Morphology: Preliminary ResultsChemical Vapor Deposition, 2008
- Reynolds and Maxwell stress measurements in the reversed field pinch experiment Extrap-T2RNuclear Fusion, 2005
- A Heatable Langmuir Probe for Alkali PlasmasContributions to Plasma Physics, 1998
- Simple heatable Langmuir probe for alkali plasmasReview of Scientific Instruments, 1997
- Creation and control of variably shaped plasmas in TCVPlasma Physics and Controlled Fusion, 1994