Study on mechanical and tribological properties of ternary fluororubber filled with four needles of zinc oxide
- 25 March 2021
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 42 (6), 3064-3076
- https://doi.org/10.1002/pc.26039
Abstract
No abstract availableKeywords
This publication has 28 references indexed in Scilit:
- Tension behaviour of HNBR and FKM elastomers for a wide range of temperaturesPolymer Testing, 2016
- Fretting Characteristics of Fluorine Rubber O-ring for Reciprocating Shaft SealJournal of Mechanical Engineering, 2015
- Accelerated wear test of FKM elastomer for life prediction of sealsPolymer Testing, 2012
- Microstructure and strengthening mechanisms in Cu/Fe multilayersActa Materialia, 2012
- Effect of filler addition and strain rate on the compressive strength of silica styrene‐butadiene rubber‐filled epoxy compositesPolymer Engineering & Science, 2011
- Effects of coupling agents on the impact fracture behaviors of T-ZnOw/PA6 compositesComposites Science and Technology, 2008
- Tribological behavior of W-DLC coated rubber sealsSurface and Coatings Technology, 2008
- Thermal characterization of Al2O3 and ZnO reinforced silicone rubber as thermal pads for heat dissipation purposesThermochimica Acta, 2005
- Effect of particle size on the properties of Mg(OH)2‐filled rubber compositesJournal of Applied Polymer Science, 2004
- Surface treatment of fluorinated rubber with triazine thiols and their propertiesJournal of Applied Polymer Science, 1994