Thermoformed Containers Based on Starch and Starch/Coffee Waste Biochar Composites
Open Access
- 18 November 2020
- Vol. 13 (22), 6034
- https://doi.org/10.3390/en13226034
Abstract
Biodegradable containers support zero-waste initiatives when alternative end-of-life scenarios are available (e.g., composting, bio digestion). Thermoplastic starch (TPS) has emerged as a readily biodegradable and inexpensive biomaterial that can replace traditional plastics in applications such as food service ware and packaging. This study has two aims. First, demonstrate the thermoformability of starch/polycaprolactone (PCL) as a thermoplastic material with varying starch loadings. Second, incorporate biochar as a sustainable filler that can potentially lower the cost and enhance compostability. Biochar is a stable form of carbon produced by thermochemical conversion of organic biomass, such as food waste, and its incorporation into consumer products could promote a circular economy. Thermoformed samples were successfully made with starch contents from 40 to 60 wt.% without biochar. Increasing the amount of starch increased the viscosity of the material, which in turn affected the compression molding (sheet manufacturing) and thermoforming conditions. PCL content reduced the extent of biodegradation in soil burial experiments and increased the strength and elongation at break of the material. A blend of 50:50 starch:PCL was selected for incorporating biochar. Thermoformed containers were manufactured with 10, 20, and 30 wt.% biochar derived from waste coffee grounds. The addition of biochar decreased the elongation at break but did not significantly affect the modulus of elasticity or tensile strength. The results demonstrate the feasibility of using starch and biochar for the manufacturing of thermoformed containers.This publication has 37 references indexed in Scilit:
- Biocomposites from waste derived biochars: Mechanical, thermal, chemical, and morphological propertiesWaste Management, 2016
- Renewable resource-based green composites of surface-treated spent coffee grounds and polylactide: Characterisation and biodegradabilityPolymer Degradation and Stability, 2015
- Green composites based on polypropylene matrix and hydrophobized spend coffee ground (SCG) powderComposites Part B: Engineering, 2015
- A novel approach in organic waste utilization through biochar addition in wood/polypropylene compositesWaste Management, 2015
- Boosting circular economy and closing the loop in agriculture: Case study of a small-scale pyrolysis–biochar based system integrated in an olive farm in symbiosis with an olive millEnvironmental Development, 2015
- Thermo-compression of biodegradable thermoplastic corn starch films containing chitin and chitosanLWT, 2014
- Tensile properties of PLLA/PCL composites filled with nanometer calcium carbonatePolymer Testing, 2013
- Biodegradation of Polylactide and Gelatinized Starch Blend Films Under Controlled Soil Burial ConditionsJournal of Polymers and the Environment, 2012
- Starch-based completely biodegradable polymer materialsExpress Polymer Letters, 2009
- Properties of thermoplastic blends: starch–polycaprolactonePolymer, 2000