Solubility Limit of Ge Dopants in AlGaN: A Chemical and Microstructural Investigation Down to the Nanoscale
- 15 January 2021
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (3), 4165-4173
- https://doi.org/10.1021/acsami.0c19174
Abstract
Attaining low-resistivity AlxGa1–xN layers is one keystone to improve the efficiency of light-emitting devices in the ultraviolet spectral range. Here, we present a microstructural analysis of AlxGa1–xN/Ge samples with 0 ≤ x ≤ 1, and a nominal doping level in the range of 1020 cm–3, together with the measurement of Ge concentration and its spatial distribution down to the nanometer scale. AlxGa1–xN/Ge samples with x ≤ 0.2 do not present any sign of inhomogeneity. However, samples with x > 0.4 display μm-size Ge crystallites at the surface. Ge segregation is not restricted to the surface: Ge-rich regions with a size of tens of nanometers are observed inside the AlxGa1–xN/Ge layers, generally associated with Ga-rich regions around structural defects. With these local exceptions, the AlxGa1–xN/Ge matrix presents a homogeneous Ge composition which can be significantly lower than the nominal doping level. Precise measurements of Ge in the matrix provide a view of the solubility diagram of Ge in AlxGa1–xN as a function of the Al mole fraction. The solubility of Ge in AlN is extremely low. Between AlN and GaN, the solubility increases linearly with the Ga mole fraction in the ternary alloy, which suggests that the Ge incorporation takes place by substitution of Ga atoms only. The maximum percentage of Ga sites occupied by Ge saturates around 1%. The solubility issues and Ge segregation phenomena at different length scales likely play a role in the efficiency of Ge as an n-type AlGaN dopant, even at Al concentrations where Ge DX centers are not expected to manifest. Therefore, this information can have direct impact on the performance of Ge-doped AlGaN light-emitting diodes, particularly in the spectral range for disinfection (≈260 nm), which requires heavily doped alloys with a high Al mole fraction.Funding Information
- Agence Nationale de la Recherche (ANR-11-LABX-0014, ANR-18-CE24-0014)
- European Regional Development Fund
- Region Normandy
- Auvergne-Rh?ne-Alpes Region
This publication has 57 references indexed in Scilit:
- The 2020 UV emitter roadmapJournal of Physics D: Applied Physics, 2020
- Ultraviolet germicidal irradiation: Possible method for respirator disinfection to facilitate reuse during the COVID-19 pandemicJournal of the American Academy of Dermatology, 2020
- UVB LEDs for Medical PhototherapyPhotonicsViews, 2019
- Inkjet printing and UV-LED curing of photochromic dyes for functional and smart textile applicationsRSC Advances, 2018
- LED revolution: fundamentals and prospects for UV disinfection applicationsEnvironmental Science: Water Research & Technology, 2017
- Germanium - the superior dopant in n-type GaNPhysica Status Solidi (RRL) – Rapid Research Letters, 2015
- Development and future of ultraviolet light-emitting diodes: UV-LED will replace the UV lampSemiconductor Science and Technology, 2014
- High Si and Ge n-type doping of GaN doping - Limits and impact on stressApplied Physics Letters, 2012
- Development of a new water sterilization device with a 365 nm UV-LEDMedical & Biological Engineering & Computing, 2007
- Effect of Si doping on strain, cracking, and microstructure in GaN thin films grown by metalorganic chemical vapor depositionJournal of Applied Physics, 2000