Rapid manufacturing of large diameter Cu micropillars by micro-electrical discharge machining and focused ion beam
- 1 February 2021
- journal article
- research article
- Published by Springer Science and Business Media LLC in The International Journal of Advanced Manufacturing Technology
- Vol. 113 (3-4), 1153-1162
- https://doi.org/10.1007/s00170-021-06699-y
Abstract
No abstract availableKeywords
Funding Information
- Kumoh National Institute of Technology
This publication has 22 references indexed in Scilit:
- Rapid production of pillar structures on the surface of single crystal CMSX-4 superalloy by femtosecond laser machiningOptics and Lasers in Engineering, 2020
- Anomalous size-dependent strength in micropillar compression deformation of commercial-purity aluminum single-crystalsMaterials Science and Engineering: A, 2020
- Fabrication and in situ compression testing of Mg micropillars with a nontrivial cross section: Influence of micropillar geometry on mechanical propertiesMaterials Science and Engineering: A, 2017
- Understanding the deformation behavior of 17-4 precipitate hardenable stainless steel produced by direct metal laser sintering using micropillar compression and TEMThe International Journal of Advanced Manufacturing Technology, 2016
- Hybrid micro-machining processes: A reviewPrecision Engineering, 2015
- Micro-pillar measurements of plasticity in confined Cu thin filmsExtreme Mechanics Letters, 2014
- Effects of focused ion beam milling on the compressive behavior of directionally solidified micropillars and the nanoindentation response of an electropolished surfaceActa Materialia, 2008
- In situ site-specific specimen preparation for atom probe tomographyUltramicroscopy, 2007
- The design of accurate micro-compression experimentsScripta Materialia, 2006
- Sample Dimensions Influence Strength and Crystal PlasticityScience, 2004