Evaluation of Prestrain Annealing Impact on Nanomaterial Sensitization
Open Access
- 4 October 2021
- journal article
- review article
- Published by Hindawi Limited in Journal of Nanomaterials
- Vol. 2021, 1-13
- https://doi.org/10.1155/2021/3175569
Abstract
Light metal alloys are extensively used in automotive, aerospace, aircraft, and military sectors since their lightweight leads to reduced energy consumption, increased fuel efficiency, and better environmental protection. In the present situation, nanomaterials are the potential candidate for weight saving in the structural application and can meet stringent government norms. Nanomaterial was heat-treated in the furnace to about a certain temperature and time and then normalized for strengthening. The heat-treated nanomaterial undergoes different forging processes, namely, hot forging and cold forging, using a certain capacity’s hydraulic press. Hence, in this work, an extensive study on the influence of the prestrain annealing, the corrosion rate on differently treated samples, and the effect of sensitization heat treatment on the nanomaterial was done.Keywords
Funding Information
- Bahir Dar University
This publication has 80 references indexed in Scilit:
- Effects of pre-strain applied at a polyethylene terephthalate substrate before the coating of TiO2 film on the coating film quality and optical performanceThin Solid Films, 2011
- Cascaded logic gates in nanophotonic plasmon networksNature Communications, 2011
- Low-Temperature Solution-Processed ZrO2 Gate Insulators for Thin-Film Transistors Using High-Pressure AnnealingElectrochemical and Solid-State Letters, 2011
- Comparison of corrosion resistance of nanostructured copper produced in vacuum and electrolytic solution in neutral chloride mediaMicro & Nano Letters, 2011
- Experimental research on the wearability, corrosion resistance, and life assessment of an aluminum alloy bridge deckTsinghua Science and Technology, 2010
- A transcendental to changing metal powder characteristicsMetal Powder Report, 2008
- DEIS assessment of AISI 304 stainless steel dissolution process in conditions of intergranular corrosionElectrochimica Acta, 2008
- Microstructure and intergranular corrosion of the austenitic stainless steel 1.4970Journal of Nuclear Materials, 2006
- Light-emitting silicon-rich nitride systems and photonic structuresJournal of Experimental Nanoscience, 2006
- Proposal of Detecting Method of Plural Cracks and Their Depth by Alternating Flux Leakage Testing: 3-D Nonlinear Eddy Current Analysis and ExperimentIEEE Transactions on Magnetics, 2004