A galvanic-based dissolved oxygen level monitoring sensor system in freshwater ponds
Open Access
- 5 March 2021
- journal article
- Published by Institute of Research and Community Services Diponegoro University (LPPM UNDIP) in Jurnal Teknologi dan Sistem Komputer
- Vol. 9 (2), 83-89
- https://doi.org/10.14710/jtsiskom.2021.13996
Abstract
This study aims to develop low-cost and environmentally friendly material galvanic-based dissolved oxygen sensors. A Dissolved oxygen (DO) sensor has been designed and fabricated on an 85 x 205 mm galvanic-based. The sensor structure device consists of Al-Zn reference layer electrode, Ag/AgCl active electrode, 120ml KCl electrolyte solvent 0,1 M, and closed by TiO2 membrane (PTFE). The Al-Zn formation reference electrode was done by Ag layer chlorination using FeCl3, and the TiO2 membrane was formed by TiO2 paste screen printing. The test was done to measure the sensor’s performance based on the current-voltage characteristics between 1.0 and 1.8 V. The results showed that a stable diffusion current was obtained when the input voltage was 1.5 V, resulting in the best sensor performance with a sensitivity of 0.7866 μA L/mg and a stable step response time of 3 mins. This prototype sensor showed high potential for prototyping for a low-cost water quality monitoring system.Keywords
Funding Information
- DRPM Ditjen Penguatan Risbang melalui skema BOPTN, Indonesia
This publication has 8 references indexed in Scilit:
- Active Potentiometry for Dissolved Oxygen Monitoring with Platinum ElectrodesSensors, 2018
- Design and Fabrication of Thick Film Dissolved Oxygen Sensor Based on RuO2 Working Electrodes for Water Quality MonitoringMaterials Science Forum, 2018
- Dissolved oxygen detection by galvanic displacement-induced graphene/silver nanocompositeBulletin of Materials Science, 2015
- PENGARUH PENGELOLAAN KUALITAS AIR TERHADAP TINGKAT KELULUSHIDUPAN DAN LAJU PERTUMBUHAN UDANG VANAME (Litopenaeus vannamei) DI PT. INDOKOR BANGUN DESA, YOGYAKARTAManagement of Aquatic Resources Journal (MAQUARES), 2013
- A Macroporous TiO2 Oxygen Sensor Fabricated Using Anodic Aluminium Oxide as an Etching MaskSensors, 2010
- Oxygen Consumption of White Shrimp (Litopenaeus vannamei) and Model of Oxygen Management in Intensive Culture PondJurnal Akuakultur Indonesia, 2007
- An “electronic tongue” design for the qualitative analysis of natural watersSensors and Actuators B: Chemical, 2005
- Microfabricated solid-state dissolved oxygen sensorSensors and Actuators B: Chemical, 2002