Comparison of formaldehyde measurements by Hantzsch, CRDS and DOAS in the SAPHIR chamber
Open Access
- 9 June 2021
- journal article
- research article
- Published by Copernicus GmbH in Atmospheric Chemistry and Physics
- Vol. 14 (6), 4239-4253
- https://doi.org/10.5194/amt-14-4239-2021
Abstract
Three instruments that use different techniques to measure gaseous formaldehyde (HCHO) concentrations were compared in experiments in the atmospheric simulation chamber SAPHIR at Forschungszentrum Jülich. One instrument (AL4021, Aero-Laser GmbH) detects HCHO using the wet-chemical Hantzsch reaction (for efficient gas-phase stripping), chemical conversion and fluorescence measurement. An internal HCHO permeation source allows for daily calibrations. This instrument was characterized by sulfuric acid titration (overall accuracy 8.6 %) and yields measurements with a time resolution of 90 s and a limit of detection (3σ) of 0.3 ppbv. In addition, a new commercial instrument that makes use of cavity ring-down spectroscopy (CRDS) determined the concentrations of HCHO, water vapour, and methane (G2307, Picarro, Inc.). Its limit of detection (3σ) is specified as 0.3 ppbv for an integration time of 300 s, and its accuracy is limited by the drift of the zero signal (manufacturer specification 1.5 ppbv). A custom-built high-resolution laser differential optical absorption spectroscopy (DOAS) instrument provided HCHO measurements with a limit of detection (3σ) of 0.9 ppbv and an accuracy of 7 % using an optical multiple reflection cell. The measurements were conducted from June to December 2019 in experiments in which either ambient air flowed through the chamber or the photochemical degradation of organic compounds in synthetic air was investigated. Measured HCHO concentrations were up to 8 ppbv. Various mixtures of organic compounds, water vapour, nitrogen oxides and ozone were present in these experiments. Results demonstrate the need to correct the baseline in measurements performed by the Hantzsch instrument to compensate for drifting background signals. Corrections were equivalent to HCHO mixing ratios in the range of 0.5–1.5 ppbv. The baseline of the CRDS instrument showed a linear dependence on the water vapour mixing ratio with a slope of ( ) ppbv %−1 below and ( ) ppbv %−1 above a water vapour mixing ratio of 0.2 %. In addition, the intercepts of these linear relationships drifted within the specification of the instrument (1.5 ppbv) over time but appeared to be equal for all water mixing ratios. Regular zero measurements are needed to account for the changes in the instrument zero. After correcting for the baselines of measurements by the Hantzsch and the CRDS instruments, linear regression analysis of measurements from all three instruments in experiments with ambient air indicated good agreement, with slopes of between 0.98 and 1.08 and negligible intercepts (linear correlation coefficients R2>0.96). The new small CRDS instrument measures HCHO with good precision and is accurate if the instrument zero is taken into account. Therefore, it can provide measurements with similar accuracy to the DOAS instrument but with slightly reduced precision compared to the Hantzsch instrument.
Keywords
Funding Information
- H2020 Excellent Science
This publication has 56 references indexed in Scilit:
- Primary and secondary sources of formaldehyde in urban atmospheres: Houston Texas regionAtmospheric Chemistry and Physics, 2012
- Formaldehyde measurements by Proton transfer reaction – Mass Spectrometry (PTR-MS): correction for humidity effectsAtmospheric Chemistry and Physics, 2010
- Ambient formaldehyde measurements made at a remote marine boundary layer site during the NAMBLEX campaign – a comparison of data from chromatographic and modified Hantzsch techniquesAtmospheric Chemistry and Physics, 2006
- Human Exposure Chamber for Known Formaldehyde Levels: Generation and ValidationIndoor and Built Environment, 2005
- Model-aided radiometric determination of photolysis frequencies in a sunlit atmosphere simulation chamberAtmospheric Chemistry and Physics, 2005
- Hydrogen peroxide, organic peroxides, carbonyl compounds, and organic acids measured at Pabstthum during BERLIOZPublished by American Geophysical Union (AGU) ,2003
- A study of formaldehyde chemistry above a forest canopyPublished by American Geophysical Union (AGU) ,2001
- Detection of tropospheric OH radicals by long‐path differential‐optical‐absorption spectroscopy: Experimental setup, accuracy, and precisionPublished by American Geophysical Union (AGU) ,1997
- Continuous Monitoring of Gaseous Formaldehyde Using an Improved Fluorescence ApproachInternational Journal of Environmental Analytical Chemistry, 1994
- Formaldehyde in indoor air: Sources and toxicityEnvironment International, 1982