Influence of plastic formation parameters on structural characteristics of thermoelectric material during hot extrusion
Open Access
- 1 December 2017
- journal article
- Published by Pensoft Publishers in Modern Electronic Materials
- Vol. 3 (4), 148-153
- https://doi.org/10.1016/j.moem.2017.11.005
Abstract
No abstract availableFunding Information
- Ministry of Education and Science of the Russian Federation (RFMEFI57914×0039-14.579.21.0039)
- Russian Basic Research Fund (15-02-01794 a)
This publication has 13 references indexed in Scilit:
- Enhanced thermoelectric and mechanical properties of zone melted p-type (Bi,Sb)2Te3 thermoelectric materials by hot deformationActa Materialia, 2015
- Mechanically Robust BiSbTe Alloys with Superior Thermoelectric Performance: A Case Study of Stable Hierarchical Nanostructured Thermoelectric MaterialsAdvanced Energy Materials, 2014
- Enhanced thermoelectric and mechanical performance of polycrystalline p-type Bi0.5Sb1.5Te3 by a traditional physical metallurgical strategyIntermetallics, 2014
- High-Temperature Mechanical and Thermoelectric Properties of p-Type Bi0.5Sb1.5Te3 Commercial Zone Melting IngotsJournal of Electronic Materials, 2013
- p-Type Bismuth Telluride-Based Composite Thermoelectric Materials Produced by Mechanical Alloying and Hot ExtrusionJournal of Electronic Materials, 2012
- Assembly Bonded at the Ends: Could Thinner and Longer Legs Result in a Lower Thermal Stress in a Thermoelectric Module Design?Journal of Applied Mechanics, 2012
- Thermal Expansion Studies of Selected High-Temperature Thermoelectric MaterialsJournal of Electronic Materials, 2009
- Microstructure control and thermoelectric properties improvement to n-type bismuth telluride based materials by hot extrusionJournal of Alloys and Compounds, 2007
- Modelling of cold extrusion with experimental verificationJournal of the American Academy of Dermatology, 2005
- Die entry pressure drops in paste extrusionChemical Engineering Science, 1998