Investigation of Hot Deformation Behavior of SNCM8 Alloy Steel
Open Access
- 1 January 2021
- journal article
- research article
- Published by Scientific Research Publishing, Inc. in World Journal of Mechanics
- Vol. 11 (03), 17-33
- https://doi.org/10.4236/wjm.2021.113003
Abstract
Plastic flow behavior of the SNCM8 steel was investigated by performing hot compression tests within the temperature range of 850˚C to 1200˚C and strain rates of 0.01 s−1 to 10 s−1. Constitutive modeling based on dynamic recrystallization was established, in which Cingara equation was applied to represent work hardening up to peak stress and Avrami equation to describe dynamic softening beyond peak stress up to steady state. It was found that stress-strain responses predicted by the combined model fairly agreed with experimentally resulted curves for the particular conditions. The correlation coefficient (R) of 0.9485 and average absolute relative error (AARE) of 2.3614% was calculated for the modeled flow curves.Keywords
This publication has 22 references indexed in Scilit:
- Hot deformation behavior of austenite in HSLA-100 microalloyed steelMaterials Science and Engineering: A, 2011
- Extrapolation of flow curves at hot working conditionsMaterials Science and Engineering: A, 2010
- Flow stress prediction at hot working conditionsMaterials Science and Engineering: A, 2010
- Numerical simulation and experimental verification of microstructure evolution in a three-dimensional hot upsetting processJournal of the American Academy of Dermatology, 2009
- Effects of deformation temperatures on stress/strain distribution and microstructural evolution of deformed 42CrMo steelMaterials & Design (1980-2015), 2009
- Constitutive equations to predict high temperature flow stress in a Ti-modified austenitic stainless steelMaterials Science and Engineering: A, 2009
- Effect of temperature and strain rate on the compressive deformation behavior of 42CrMo steelJournal of the American Academy of Dermatology, 2008
- Mathematical modelling of the stress–strain curves of Ti-IF steel at high temperatureJournal of the American Academy of Dermatology, 2006
- The constitutive equations for FEM analysisJournal of the American Academy of Dermatology, 2000
- The plastic deformation behaviour of AISI 4340 alloy steel subjected to high temperature and high strain rate loading conditionsJournal of the American Academy of Dermatology, 1997