Experimental Study on Surface Roughness and Flank Wear in Turning of Nimonic C263 under Dry Cutting Conditions
Open Access
- 12 October 2021
- journal article
- retracted article
- Published by Hindawi Limited in Journal of Nanomaterials
- Vol. 2021, 1-11
- https://doi.org/10.1155/2021/2054399
Abstract
Aircraft component manufacturing sector is looking for high precision machining in aircraft components. The present work explores the operability of green manufacturing of Nimonic C263 using dry turning. Nimonic C263 is tough to turn owing to its inherent quality like low conductivity and more work hardening. Therefore, in order to improve this machined surface/integrity, the controlling factors were optimized based on desirability approach for minimum of surface roughness and flank wear during turning of this alloy using CBN insert. L27 orthogonal array was chosen to carry out the experiment. The effects of controlling factors, such as cutting speed ( V ), feed rate ( S ), and cut penetration/depth of cut ( a p ) on the outputs, were also explored. The feed rate was a major impact to affect surface finish and flank wear. The average error percentage between the experimental and RSM models for surface finish was 4.76 percent and 2.79 percent for flank wear.Keywords
This publication has 16 references indexed in Scilit:
- Sustainability Assessment and Machinability Investigation of Austenitic Stainless Steel in Finish Turning with Advanced Ultra-Hard SiAlON Ceramic Tool under Different Cutting EnvironmentsSilicon, 2020
- A comparative investigation of Taguchi and full factorial design for machinability prediction in turning of a titanium alloyMeasurement, 2019
- Machining performance of PCD and PCBN tools in dry turning titanium alloy Ti-6Al-0.6Cr-0.4Fe-0.4Si-0.01BThe International Journal of Advanced Manufacturing Technology, 2019
- Influence of Different Grades of CBN Inserts on Cutting Force and Surface Roughness of AISI H13 Die Tool Steel during Hard Turning OperationMaterials, 2019
- PCBN Performance in High Speed Finishing Turning of Inconel 718Metals, 2018
- Experimental study of the wear behavior of PCBN inserts during cutting of GH4169 superalloys under high-pressure coolingThe International Journal of Advanced Manufacturing Technology, 2017
- Investigation and modeling of flank wear process of different PCD tools in cutting titanium alloy Ti6Al4VThe International Journal of Advanced Manufacturing Technology, 2017
- Observation of a unique wear morphology of cBN inserts during machining of titanium metal matrix composites (Ti-MMCs); leading to new insights into their machinabilityThe International Journal of Advanced Manufacturing Technology, 2017
- An investigation on surface finish and flank wear in hard machining of solution treated and aged 18 % Ni maraging steelJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2016
- Machining of Nickel Alloy 242 with Cubic Boron Nitride ToolsJournal of Applied Sciences, 2010