Micro powder injection molding of boron carbide components with SiC-Al2O3-Y2O3 sintering additives
Open Access
- 17 August 2020
- journal article
- research article
- Published by Elsevier BV in Chinese Journal of Aeronautics
- Vol. 35 (5), 429-440
- https://doi.org/10.1016/j.cja.2020.08.005
Abstract
No abstract availableKeywords
This publication has 40 references indexed in Scilit:
- Spark plasma sintering of B4C ceramics: The effects of milling medium and TiB2 additionInternational Journal of Refractory Metals and Hard Materials, 2012
- Microstructure and high-temperature strength of B4C–TiB2 composite prepared by a crucibleless zone melting methodJournal of Alloys and Compounds, 2009
- Sand erosion performance of B4C based ceramic nozzlesInternational Journal of Refractory Metals and Hard Materials, 2008
- Erosion wear of boron carbide ceramic nozzles by abrasive air-jetsMaterials Science and Engineering: A, 2005
- Machining of hot pressed alumina–boron carbide composite cutting toolInternational Journal of Refractory Metals and Hard Materials, 2005
- Mechanical and electrical properties of B4C–CrB2 ceramics fabricated by liquid phase sinteringCeramics International, 2003
- High temperature sintering of SiC with oxide additives: I. Analysis in the SiC–Al2O3 and SiC–Al2O3–Y2O3 systemsJournal of the European Ceramic Society, 2003
- Solid-state reactions in Y2O3:3Al2O3:4B2O3 system studied by FTIR spectroscopy and X-ray diffractionVibrational Spectroscopy, 2000
- Mechanical Properties of Injection Molded B4C–C CeramicsJournal of Solid State Chemistry, 1997
- Reactive formation of coatings at boron carbide interface with Ti and Cr powdersJournal of the European Ceramic Society, 1995