Magnetron configurations dependent surface properties of SnO2 thin films deposited by sputtering process
- 3 April 2020
- journal article
- research article
- Published by Elsevier BV in Vacuum
- Vol. 177, 109353
- https://doi.org/10.1016/j.vacuum.2020.109353
Abstract
No abstract availableKeywords
Funding Information
- CSIR-National Physical Laboratory, New Delhi, India
- Department of Science & Technology (DST) through SERB, New Delhi, India (SB/EMEQ-040/2014)
This publication has 37 references indexed in Scilit:
- Photoluminescence Studies on Nanocrystalline Tin Oxide Powder for Optoelectronic DevicesAmerican Journal of Materials Science, 2012
- Synthesis of Anatase Titania Nanostructures at Room Temperature by PECVD TechniqueJournal of Materials Science & Technology, 2011
- Microstructural, Optical, and Electrical Properties of SnO Thin Films Prepared on Quartz via a Two-Step MethodACS Applied Materials & Interfaces, 2010
- Facile Synthesis of Pt-Functionalized SnO[sub 2] Hollow Hemispheres and Their Gas Sensing PropertiesJournal of the Electrochemical Society, 2010
- Geometry, electronic structure and thermodynamic stability of intrinsic point defects in indium oxideJournal of Physics: Condensed Matter, 2009
- Energetic and Electronic Structure Analysis of Intrinsic Defects in SnO2The Journal of Physical Chemistry C, 2008
- Preparation and characterization of SnO2films for sensing applicationsJournal of Physics: Conference Series, 2008
- Nano-particle thin films of tin oxidesMaterials Letters, 2007
- Reconfigurable hydrophobic/hydrophilic surfaces in microelectromechanical systems (MEMS)Journal of Micromechanics and Microengineering, 2003
- A comparison of different methods to calculate the surface free energy of wood using contact angle measurementsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2001