Alternative Propellant Nuclear Thermal Propulsion Engine Architectures
- 1 July 2022
- journal article
- research article
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Spacecraft and Rockets
- Vol. 59 (4), 1149-1160
- https://doi.org/10.2514/1.a35289
Abstract
Recently, NASA’s Artemis Program has considered sustainably returning humans to the moon with in situ resource utilization as the central focus and considers nuclear thermal propulsion (NTP) to be a viable propulsion system candidate for deep space missions. This program also considers the moon to function as a staging area for deep space missions due to its strategic orbit around Earth. The Lunar Crater Observation and Sensing Satellite discovered the abundancy of water, ammonia, and other volatiles in permanently shadowed regions on the moon. Because NTP can theoretically use any fluid as a propellant, water and ammonia are two potential alternative propellants to hydrogen that do not require postprocessing to be used directly in situ. Alternative propellant NTP engine models were developed to examine the performance of water and ammonia. It was found that bleed cycle architectures are infeasible with current turbine materials, but expander cycles have acceptable turbine inlet temperatures with marginal performance differences from bleed cycles. At reactor power levels comparable to hydrogen NTP engines, water doubles the thrust while ammonia increases it by 70%, although at a much lower specific impulse. The largest contributor to the life of the engine was the maximum temperature of the SiC cladding for water and the maximum temperature of the fuel for ammonia where higher values resulted in shorter engine life.Keywords
Funding Information
- NASA Space Technology Mission Directorate (MSFC-UAH 2D0QA)
This publication has 23 references indexed in Scilit:
- Silicon Carbide Oxidation in High‐Pressure SteamJournal of the American Ceramic Society, 2013
- Model for Ammonia Solar Thermal ThrusterJournal of Thermophysics and Heat Transfer, 2006
- Neutron scattering lengths and cross sectionsNeutron News, 1992
- A generalized correlation for two-phase forced flow heat transferInternational Journal of Heat and Mass Transfer, 1988
- Calculation of void volume fraction in the subcooled and quality boiling regionsInternational Journal of Heat and Mass Transfer, 1970
- A Study on Design Criteria and Matching of Turbomachines: Part A—Similarity Relations and Design Criteria of TurbinesJournal of Engineering for Power, 1962
- A Study on Design Criteria and Matching of Turbomachines: Part B—Compressor and Pump Performance and Matching of TurbocomponentsJournal of Engineering for Power, 1962
- Technical NotesJournal of Jet Propulsion, 1957
- THE THERMAL DECOMPOSITION OF AMMONIA ON TUNGSTEN, MOLYBDENUM AND NICKEL. IJournal of the American Chemical Society, 1928
- CLIII.—The thermal decomposition of ammonia upon various surfacesJournal of the Chemical Society, Transactions, 1925