Effects of stacking fault energy and solute atoms on microstructural evolution of Cu, Ag and Cu–Al alloys processed by equal channel angular pressing
- 29 December 2020
- journal article
- research article
- Published by Elsevier BV in Materials Science and Engineering: A
- Vol. 803, 140716
- https://doi.org/10.1016/j.msea.2020.140716
Abstract
No abstract availableKeywords
Funding Information
- Japan Society for the Promotion of Science
This publication has 61 references indexed in Scilit:
- Mechanical, microstructural and electrical evolution of commercially pure copper processed by equal channel angular extrusionMaterials Science and Engineering: A, 2013
- Microstructure and mechanical properties of Cu and Cu–Zn alloys produced by equal channel angular pressingMaterials Science and Engineering: A, 2011
- Evolution of defect structures during cold rolling of ultrafine-grained Cu and Cu–Zn alloys: Influence of stacking fault energyMaterials Science and Engineering: A, 2008
- Influence of stacking fault energy on nanostructure formation under high pressure torsionMaterials Science and Engineering: A, 2005
- Physics and phenomenology of strain hardening: the FCC caseProgress in Materials Science, 2003
- Evidence for Suzuki effect in an Fe-Ni-Cr austenitic stainless steelPhilosophical Magazine A, 1995
- A new mechanism of work hardening in the late stages of large strain plastic flow in F.C.C. and diamond cubic crystalsActa Metallurgica et Materialia, 1993
- Cold work hardening in stages IV and V of F.C.C. metals—II. Model fits and physical resultsActa Metallurgica et Materialia, 1993
- Cold work hardening in stages IV and V of F.C.C. metals—I. Experiments and interpretationActa Metallurgica et Materialia, 1993
- Mechanisms of slip mode modification in F.C.C. solid solutionsActa Metallurgica et Materialia, 1990