Simulation of activated corrosion product activity in Korean design system-integrated modular advanced reactor (SMART) under steady-state flow and linearly accelerated corrosion
- 1 April 2021
- journal article
- research article
- Published by Elsevier BV in Progress in Nuclear Energy
Abstract
No abstract availableKeywords
Funding Information
- Kementerian Pendidikan Malaysia
- King Abdulaziz University
This publication has 30 references indexed in Scilit:
- Activation analysis of coolant water in ITER blanket and divertorFusion Engineering and Design, 2012
- Kinetic simulation of fission product activity in primary coolant of typical PWRs under power perturbationsNuclear Engineering and Design, 2007
- The evaluation of radioactive corrosion product at PWR as change of primary coolant chemistry for long-term fuel cycleAnnals of Nuclear Energy, 2003
- Modeling and simulation of corrosion product activity in pressurized water reactors under power perturbationsAnnals of Nuclear Energy, 1999
- Accumulation of radioactive corrosion products on steel surfaces of VVER type nuclear reactors. I. 110mAgJournal of Nuclear Materials, 1999
- Simulation of corrosion product activity in pressurized water reactors under flow rate transientsAnnals of Nuclear Energy, 1998
- Speciation and analysis of corrosion products in the primary coolant of pressurized water reactorsAnalytica Chimica Acta, 1987
- Some aspects of system chemistry of BWRsProgress in Nuclear Energy, 1978
- Mass transfer in turbulent pipe flow measured by the electrochemical methodInternational Journal of Heat and Mass Transfer, 1977
- A sub layer model for the deposition of particles from a turbulent flowChemical Engineering Science, 1975