Constraining the 410-km discontinuity and slab structure in the Kuril subduction zone with triplication waveforms
- 4 September 2021
- journal article
- research article
- Published by Oxford University Press (OUP) in Geophysical Journal International
- Vol. 228 (2), 729-743
- https://doi.org/10.1093/gji/ggab361
Abstract
SUMMARY: The detailed structure near the 410-km discontinuity provides key constraints of the dynamic interactions between the upper mantle and the lower mantle through the mantle transition zone (MTZ) via mass and heat exchange. Meanwhile, the temperature of the subducting slab, which can be derived from its fast wave speed perturbation, is critical for understanding the mantle dynamics in subduction zones where the slab enters the MTZ. Multipathing, i.e. triplicated, body waves that bottom near the MTZ carry rich information of the 410-km discontinuity structure and can be used to constrain the discontinuity depth and radial variations of wave speeds across it. In this study, we systematically analysed the trade-off between model parameters in triplication studies using synthetic examples. Specifically, we illustrated the necessity of using array-normalized amplitude. Two 1-D depth profiles of the wave speed below the Tatar Strait of Russia in the Kuril subduction zone are obtained. We have observed triplications due to both the 410-km discontinuity and the slab upper surface. And, seismic structures for these two interfaces are simultaneously inverted. Our derived 410-km discontinuity depths for the northern and southern regions are at 420$\pm $15 and 425$\pm $15 km, respectively, with no observable uplift. The slab upper surface is inverted to be located about 50–70 km below the 410-km discontinuity. This location is between the depths of the 1 and 2 per cent P-wave speed perturbation contours of a regional 3-D full-waveform inversion (FWI) model, but we found twice the wave speed perturbation amplitude. A wave speed increase of 3.9–4.6 per cent within the slab, compared to 2.0–2.4 per cent from the 3-D FWI model, is necessary to fit the waveforms with the shortest period of 2 s, indicating that high-frequency waves are required to accurately resolve the detailed structures near the MTZ.Funding Information
- NSF (ACI-1053575, 1802247)
This publication has 75 references indexed in Scilit:
- Upper mantle P velocity structure beneath the Midwestern United States derived from triplicated waveformsGeochemistry, Geophysics, Geosystems, 2012
- A sporadic low-velocity layer atop the western U.S. mantle transition zone and short-wavelength variations in transition zone discontinuitiesGeochemistry, Geophysics, Geosystems, 2011
- Distinct velocity variations around the base of the upper mantle beneath northeast AsiaPhysics of the Earth and Planetary Interiors, 2009
- Global‐scale analysis of the mantle Pds phasesJournal of Geophysical Research, 1999
- A map of topography on the 410‐km discontinuity from PP precursorsGeophysical Research Letters, 1999
- Fine structure of the 410‐km discontinuityJournal of Geophysical Research, 1998
- Global mapping of topography on transition zone velocity discontinuities by stacking SS precursorsJournal of Geophysical Research, 1998
- Topography of the “410” and “660” km seismic discontinuities in the Izu‐Bonin Subduction ZoneGeophysical Research Letters, 1997
- Phase transition Clapeyron slopes and transition zone seismic discontinuity topographyJournal of Geophysical Research, 1994
- Distribution of stresses in the descending lithosphere from a global survey of focal‐mechanism solutions of mantle earthquakesReviews of Geophysics, 1971