Air-Water Mist Cooling Characteristics of an MS Plate in a Laboratory Scale ROT - An Experimental Observation
- 15 April 2021
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 903, 45-49
- https://doi.org/10.4028/www.scientific.net/amm.903.45
Abstract
Steels of various grades are ubiquitous in the modern economy. Cooling of steel during the production process is an important deciding factor about its final mechanical properties. This is dependent on the characteristics of the industrial setup and coolant used. Studies have been undertaken for analysis of their influence on the cooling rate, given specific parameters, for suitable industrial use and optimal production. The present study and experiments undertaken highlight the variation of the cooling rate of a Mild Steel Plate in a miniaturized Run Out Table (ROT), using airwater mist spray cooling under different initial plate temperatures and nozzle bank distances.Keywords
This publication has 10 references indexed in Scilit:
- Heat transfer enhancement using air-atomized spray cooling with water–Al2O3 nanofluidInternational Journal of Thermal Sciences, 2015
- Jet Impingement Cooling of a Hot Moving Steel Plate: An Experimental StudyExperimental Heat Transfer, 2015
- IMPINGEMENT COOLING OF HOT METAL STRIPS IN RUNOUT TABLE - A REVIEWInterfacial Phenomena and Heat Transfer, 2015
- Ultra fast cooling of hot steel plate by air atomized spray with salt solutionHeat and Mass Transfer, 2013
- Performance enhancement of air-cooled chillers with water mist: Experimental and analytical investigationApplied Thermal Engineering, 2012
- Air‐Water Mist and Homogeneity Degree of Spray Cooling Zones for Improving Quality in Continuous Casting of SteelSteel Research International, 2011
- Analysis on Influence Factors of the Cooling Efficiency of Moderate Thick Plates in the Quenching with Controlled CoolingPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2010
- A model for deformation, temperature and phase transformation behavior of steels on run-out table in hot strip millJournal of the American Academy of Dermatology, 2002
- Cooling of a Heated Surface by Mist FlowJournal of Heat Transfer, 1994
- Advanced Strategies for the Controlled Cooling of SteelIFAC Proceedings Volumes, 1992