Complete Parameter Identification of Gough-Stewart Platform with Partial Pose Measurements
- 1 January 2006
- journal article
- Published by Japan Society of Mechanical Engineers in JSME International Journal Series C
- Vol. 49 (4), 1107-1115
- https://doi.org/10.1299/jsmec.49.1107
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- Complete parameter identification of parallel manipulators with partial pose information using a new measurement deviceRobotica, 2004
- Calibration of parallel robots using two inclinometersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2003
- Self-calibration of a class of parallel manipulatorsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- A calibration procedure for the parallel robot Delta 4Published by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- A new method for fully autonomous calibration of parallel manipulators using a constraint linkPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Self calibration of Stewart-Gough parallel robots without extra sensorsIEEE Transactions on Robotics and Automation, 1999
- Calibration of stewart platforms and other parallel manipulators by minimizing inverse kinematic residualsJournal of Robotic Systems, 1998
- Self-calibration of parallel mechanisms with a case study on Stewart platformsIEEE Transactions on Robotics and Automation, 1997
- The Calibration Index and Taxonomy for Robot Kinematic Calibration MethodsThe International Journal of Robotics Research, 1996
- An implicit loop method for kinematic calibration and its application to closed-chain mechanismsIEEE Transactions on Robotics and Automation, 1995