Comparative Wear Resistance of Existing and Prospective Materials of Fast-Wearing Elements of Mining Equipment
- 27 July 2021
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1040, 117-123
- https://doi.org/10.4028/www.scientific.net/msf.1040.117
Abstract
The results of tests for resistance to abrasive wear on highly abrasive hard rock white electrocorundum are presented. The main material of fast-wearing elements of mining and processing equipment-110G13L steel (Gadfield steel) in comparison with other 9 grades of steel and cast iron, including specially developed wear-resistant foreign steels such as Hardox and Miiluks, is analyzed. The studies were carried out using an experimental stand for studying the material wearing process. On the stand the sample was fixed in a holding device and, after being brought into contact with the abrasive, it was rotated under a constant load. As a result of the experiments, it was confirmed that the order of placement of the tested materials in terms of increasing wear resistance coincides with their placement in terms of increasing hardness. At the same time, the wear resistance of the most resistant material – U8A steel after quenching – is about 4 times higher than this indicator for the least resistant components – low-carbon steel 25L, including gray and high-strength cast iron SCH21, VCH35. The wear resistance of 110G13L steel, as well as 65G, U8 steels in the hardened state, is from 1.5 to 2 times higher than that of foreign steels M400, H450, M500, H500. The results of the conducted studies allow us to evaluate the analyzed materials on the basis of their wear resistance and hardness indicators on the feasibility of using them in the manufacture of fast-wearing parts of mining equipment. Based on the research data, it seems promising to develop new ways to increase the wear resistance of domestic steel, including 110G13L steel traditionally used in mining.Keywords
This publication has 10 references indexed in Scilit:
- Estimation of abrasiveness impact on the parameters of rock-cutting equipmentJournal of Mining Institute, 2019
- Creating a model of diffusion deposition of metal coatings from melts of low-melting metalsIOP Conference Series: Materials Science and Engineering, 2019
- The use of nanomaterials to improve the wear resistance of machine parts under fretting corrosion conditionsIOP Conference Series: Materials Science and Engineering, 2019
- Influence of W Addition on Microstructure and Mechanical Properties of Al-12%Si AlloysMaterials, 2019
- STUDY OF BEARING UNITS WEAR RESISTANCE OF ENGINES CAREER DUMP TRUCKS, WORKING IN FRETTING CORROSION CONDITIONSJournal of Mining Institute, 2019
- Influence of Thermomechanical Treatment Modes on Wear Resistance of Mining Equipment MaterialMaterials Science Forum, 2019
- Recovery of worn-out picks in rock breakingEurasian Mining, 2018
- Integrated Quality Ensuring Technique of Plasma Wear Resistant CoatingsKey Engineering Materials, 2017
- Design of new-class picks for cutter–loadersGornyi Zhurnal, 2017
- Upgrading of effectors of heading-and-winning machines “Ural”Gornyi Zhurnal, 2016