Abstract
En tr In this study, effects of some physiographic factors (aspect, slope and elevation) on breast diameter, height and cone properties (cone weight, number of cones, cone width and cone length) in stone pine (Pinus pinea L.) afforestation areas in Balıkesir-Burhaniye region were investigated. To determine to effects of physiographic conditions, study area is separated according to aspect, slope and elevation groups. Aspect is separated two groups which are shady aspect (B1) and sunny aspect (B2). Slope is separated two groups which are small from 36 percent (E1) and big from 36 percent (E2). Elevation also is separated two groups which are under 400 meters (Y1) and over 400 meters (Y2). Sample areas were scattering to land classifications by using Stratified Sampling Method. Thus, each aspect, slope and elevation classifications were obtained from sample area where are provided from 32 different areas. Tree heights, the diameter at breast height and cone number were measured on saplings. In addition, in each sample area five Pinus pinea trees were selected. It was measured cone diameter, cone height and air-dries weight values of cones which are picked from selecting trees. According to statistical analysis results, aspect effects to tree heights, cone number and cone weight; slope effects the diameter at breast height, cone number and cone diameter; elevation effects the diameter at breast height, tree height, cone number and cone weight. In terms of tree height and diameter values; the highest average breast height diameter was found in the B1E1Y1 with 13.6 cm, and the highest average height value was found in the B2E2Y2 by interaction. In terms of cone characteristics; with the highest average cone number of 8.5 in B1E1Y1, the highest mean cone weight in B1E1Y1 with 232 gr and the highest cone diameter in B2E2Y1 with 5.4 cm. According to the results of correlation analysis; it was determined that slope and elevation factors have positive effect on breast height diameter. At the same time, aspect and elevation have positive effect on height. Although aspect and slope factors have negative correlation with number of cones, but elevation has positive correlation as well. Both three factors have positive correlation with cone diameter. On the other hand, cone height has negative correlation with slope and positive correlation with elevation Bu çalışmada, bazı fizyografik etmenlerin (bakı, eğim ve yükselti) Balıkesir-Burhaniye yöresi fıstıkçamı (Pinus pinea L.) ağaçlandırmalarının çap ve boy değerleri ile kozalak özellikleri (kozalak ağırlığı, kozalak sayısı, kozalak eni ve kozalak boyu) üzerine olan etkileri araştırılmıştır. Fizyografik etmenlerin etkilerini belirleyebilmek amacıyla çalışma alanı, bakı, eğim ve yükselti gruplarına ayrılmıştır. Buna göre; gölgeli (B1) ve güneşli (B2) olmak üzere iki bakı grubu, %36’dan düşük (E1) ve %36’dan fazla (E2) olmak üzere iki eğim grubu ve 400 m’den düşük (Y1) ve 400 m’den fazla (Y2) olmak üzere iki yükselti grubu oluşturulmuştur. Tabakalı örnekleme yöntemi ile örnek alanlar bu arazi sınıflarına dağıtılmıştır. Çalışma, 32 adet örnek alandan sağlanan verilerle yürütülmüştür. Örnek alanlarda ağaç boyu, göğüs çapı ve kozalak sayısı değerleri ile her örnek alanda 5 adet olmak üzere seçilen örnek ağaçlardan toplanan kozalakların çap, boy ve hava kurusu ağırlık değerleri ölçülmüştür. İstatistiksel değerlendirmelere göre; bakı etmeninin ağaç boyu, kozalak sayısı ve kozalak ağırlığı üzerinde, eğim etmeninin ağaç çapı, kozalak sayısı ve kozalak çapı üzerinde, yükselti etmeninin de ağaç çapı, ağaç boyu, kozalak sayısı ve kozalak ağırlığı üzerinde etkili oldukları belirlenmiştir. Ağaç boy ve çap değerleri bakımından; en yüksek ortalama göğüs çapı 13.6 cm ile B1E1Y1’de, en yüksek ortalama boy değeri B2E2Y2 ortak etkileşiminde bulunmuştur. Kozalak özellikleri bakımından; en yüksek ortalama kozalak sayısı 8.5 adet ile B1E1Y1’de, en yüksek ortalama kozalak ağırlığı 232 gr ile B1E1Y1’de, en yüksek kozalak çapı ise 5.4 cm ile B2E2Y1 ortak etkileşiminde elde edilmiştir. Korelasyon analizi sonuçlarına göre; göğüs çapı üzerinde eğim ve yükselti etmenlerinin pozitif yönde bir etkisi olduğu belirlenmiştir. Boy üzerinde ise bakı ve yükselti etmenleri pozitif etki göstermektedir. Kozalak sayısı ile bakı ve eğim negatif, yükselti ise pozitif ilişkilidir. Kozalak çapı ile her üç etmen, pozitif ilişki içerisindedir. Kozalak boyu ise, eğim etmeni ile negatif, yükselti etmeni ile pozitif bir ilişki göstermektedir.