Analysis of Paint Flow Pulsations during High-Speed Rotary Bell Atomization
Open Access
- 17 October 2019
- Vol. 9 (10), 674
- https://doi.org/10.3390/coatings9100674
Abstract
High-speed rotary bell atomization is the preeminent coating technique in the automotive industry. It is widely accepted that a narrow droplet size distribution and constant spray are necessary in order to guarantee uniform film thickness and high-quality appearance. This may be deteriorated by paint flow pulsations. So far, however, no studies exist regarding such fluctuations quantitatively for this type of atomizers. We fill this gap using image analysis of high-speed recordings close to the bell edge. We could show that the fundamental pulsation frequency increases linearly with rotational speed. A ratio of pulsation frequency and true rotational speed of about 3 was found, indicating that pulsations were initiated mainly by the three struts of the distributor disc. The coefficient of variation, i.e., the amplitude of fluctuation increased with decreasing liquid volume rate and rotational speed. Beyond that, we could show that the formation of droplets larger than 100 μm, which are assumed to cause paint defects, is promoted by the degree of fluctuation. These findings may stimulate development of bell cups showing less paint flow pulsations.Keywords
This publication has 18 references indexed in Scilit:
- Log-Normal Melt Pulsation in Close-Coupled Gas AtomizationMetallurgical and Materials Transactions B, 2013
- EFFERVESCENT ATOMIZATION OF POLYVINYLPYRROLIDONE SOLUTIONS: INFLUENCE OF LIQUID PROPERTIES AND ATOMIZER GEOMETRY ON LIQUID BREAKUP AND SPRAY CHARACTERISTICSAtomization and Sprays, 2013
- Numerical and experimental investigations on the breakup of particle laden liquid jets in the centrifugal fieldChemical Engineering Science, 2012
- Characteristics of Mean Droplet Size Produced by Spinning Disk AtomizersJournal of Fluids Engineering, 2012
- Liquid Atomization Using a Rotary Bell Cup Atomizer (Influence of Flow Characteristics of Liquid on Breakup Pattern)Journal of Fluid Science and Technology, 2010
- SELF-PULSATION CHARACTERISTICS OF A GAS-LIQUID SWIRL COAXIAL INJECTORAtomization and Sprays, 2009
- High-speed cinematography of gas-metal atomizationMaterials Science and Engineering: A, 2005
- Characterizing Spray Pulsations Using a Phase-Doppler Particle AnalyzerIndustrial & Engineering Chemistry Research, 2001
- Rotary atomization in the ligament formation modeJournal of Agricultural Engineering Research, 1981
- Analysis of a polydisperse aqueous spray from a high-speed spinning disk atomizerBritish Journal of Applied Physics, 1959