Utilization of Arduino Control in Mitigating the Hybrid Harmonics of DC/AC Inverter
Open Access
- 10 September 2021
- journal article
- Published by Lattice Science Publication (LSP) in Indian Journal of VLSI Design
- Vol. 1 (2), 5-8
- https://doi.org/10.54105/ijvlsid.b1202.091221
Abstract
This Paper deals with the implementation of Harmonics distortion in distribution system by using the method of hybrid of active filter and passive filters. The active filter is used to reduce the distortion present in the output. Boost converter is used to increase the voltage level. This boost converter is connected to the inverter, which is designed by using the MOSFET as a switch. In practical application the pulses for the inverter is given by using the Arduino control. By using this hybrid method, the total harmonics distortion is reduced to below the acceptable limit. Simulation for this proposed method is done by using the MATLAB simulink. Initially, fast fourier transform may found to mitigate harmonics. But emerging technologies like Arduino control is proved to simple and economical in carrying out the same task effectively.Keywords
This publication has 6 references indexed in Scilit:
- Feedforward Harmonic Mitigation Strategy for Single-Phase Voltage Source ConverterJournal of Electrical and Computer Engineering, 2018
- Harmonic analysis in Microgrid and distributed energy system using Harmonic Balance MethodPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2016
- Harmonic Cancellation of PV-supplied DC/AC Converter without Stabilizing Input CapacitorsIFAC-PapersOnLine, 2016
- Current Harmonics Compensation in Microgrids Exploiting the Power Electronics Interfaces of Renewable Energy SourcesEnergies, 2015
- Low Order Harmonic Cancellation in a Grid Connected Multiple Inverter System Via Current Control Parameter RandomizationIEEE Transactions on Power Electronics, 2005
- Opportunities for harmonic cancellation with carrier-based PWM for a two-level and multilevel cascaded invertersIEEE Transactions on Industry Applications, 2001