Surface Finishing of Micro-channels Using Low Kinetic Energy Abrasives
Open Access
- 1 January 2014
- journal article
- Published by Avestia Publishing in International Journal of Mechanical Engineering and Mechatronics
Abstract
No abstract availableKeywords
This publication has 15 references indexed in Scilit:
- Surface roughness and erosion rate of abrasive jet micro-machined channels: Experiments and analytical modelWear, 2013
- A wet abrasive blasting process for smooth micromachining of glass by ductile-mode removalJournal of Micromechanics and Microengineering, 2008
- Micro-grooving of glass using micro-abrasive jet machiningJournal of the American Academy of Dermatology, 2004
- Mechanics of adhesion in MEMS—a reviewJournal of Adhesion Science and Technology, 2003
- Fine tuning the roughness of powder blasted surfacesJournal of Micromechanics and Microengineering, 2002
- Powder blasting for the realisation of microchips for bio-analytic applicationsSensors and Actuators A: Physical, 2001
- Powder-blasting technology as an alternative tool for microfabrication of capillary electrophoresis chips with integrated conductivity sensorsJournal of Micromechanics and Microengineering, 2001
- Erosion and damage by sharp particlesWear, 1998
- Roughness, inhomogeneity, and integrated opticsJournal of Lightwave Technology, 1997
- Elastic/Plastic Indentation Damage in Ceramics: The Lateral Crack SystemJournal of the American Ceramic Society, 1982